Black Box LB9020A-R2 User manual

Installation

This installation guide gives step-by-step instructions about how to install the Express Plus Ethernet Switches:

LB9020A-R2

Selecting a Site for the Express Ethernet Switch: LB9020A-R2

As with any electric device, you should place the switch where it will not be subjected to extreme temperatures,

humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements:

-The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius).

-The relative humidity should be less than 90 percent, non-condensing.

-Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3,

Level 2 (3V/M) fieldstrength.

-Make sure that the switch receives adequate ventilation. Do not block the ventilation holes on each side of the

switch or the fan exhaust port on the rear of the switch.

-The power outlet should be within 1.8 meters of the switch.

Connecting to Power

?? Connect the supplied AC power cord to the receptacle on the back of the switch, and then plug it into

a standard AC outlet with a voltage range from 100 to 260 Vac.

Figure: Rear view of the switch

Connecting to Your Network

Cabling

?? First, ensure the power of the switch and end devices is turned off.

<NOTE> Always ensure that the power is off before any installation.

?? Prepare cable with corresponding connectors for each type of port in use.

?? Consult Table 2 below for cabling requirements based on connectors and speed.

?? Connect one end of the cable to the switch and the other end to a desired PC or workstation.

?? Once the connections between two end devices are made successfully, turn on the power and the

switch is operational.

Receptacle

Cable Length

The maximum distance of a node to a directly connected switch on a 100BASE-TX network is 100 meters with

Category 5 shielded twisted-pair (STP) cable or unshielded twisted-pair (UTP) cable. For a 10BASE-T network, it

may range up to 100 meters with Category 3, 4, or 5 STP/UTP cable.

The maximum segment distance between a node and a directly connected switch port on a 100BASE-FX network is

75 km using 10/125(or 9/125)µm single-mode fiber optic cable. It is capable of spanning at most 2 kilometers when

use of 62.5/125(or 50/125)µmmulti-mode fiber-optic cable.

Table: Cable Specifications Ethernet

Standards Connector Port

Speed

Half/Full

Duplex

Cable Max.

Distance

10BASE-TRJ-45 10/20

Mbps Cat. 3, 4 or 5

UTP/STP 100 m

100BASE-TX

RJ-45 100/200

Mbps Cat. 5

UTP/STP 100 m

CUSTOMER Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX

SUPPORT FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746

INFORMATION Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web Site: www.blackbox.com ?E-mail: [email protected]

Other manuals for LB9020A-R2

Table of contents

Other Black Box Switch manuals

Black Box

Black Box SW614A User manual

Black Box

Black Box LE2700A User manual

Black Box

Black Box IC1020A User manual

Black Box

Black Box SWI081A User manual

Black Box

Black Box ServMaster User manual

Black Box

Black Box SW1003A User manual

Black Box

Black Box IC650A User manual

Black Box

Black Box LPB2810A User manual

Black Box

Black Box KV9404A User manual

Black Box

Black Box ServSwitch DT Pro II KV7020A User manual

Black Box

Black Box SW421A-R2 User manual

Black Box

Black Box LB8508A User manual

Black Box

Black Box SERVSWITCH PANTHER KV1108A User manual

Black Box

Black Box SWI035A User manual

Black Box

Black Box Maverick SW161A User manual

Black Box

Black Box 26611 User manual

Black Box

Black Box EMS1G-48 User manual

Black Box

Black Box KV6202A User manual

Black Box

Black Box LPB1305A User manual

Black Box

Black Box LGB1001A User manual

Black Box

Black Box ServSwitch DT Pro II KV7020A User manual

Black Box

Black Box LGB708A-R4 User manual

Black Box

Black Box DDC Ghost User manual

Black Box

Black Box ServSwitch Jr. SW621A-R2 User manual

Popular Switch manuals by other brands

URC

URC Total Control MFS-8 installation manual

Azbil

Azbil HPQ-D11 user manual

Sony

Sony DFS-900M operating instructions

SICK

SICK i17S operating instructions

F&F

F&F SZR-277 quick start guide

Shure

Shure UAMS/BK user guide

Dräger

Dräger X-zone Switch Off Instructions for use

Asco

Asco Joucomatic 349 Series manual

BT Mini Hub user guide

D-Link

D-Link DES-1226G manual

Johnson Controls

Johnson Controls FS80-C installation instructions

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Configuration guide

MicroNet

MicroNet SP1200A user manual

Ruijie

Ruijie RG-PF2920 Series Hardware installation and reference guide

Altinex

Altinex DA1914SX user guide

MiLAN

MiLAN MIL-SM2401M user guide

RJM

RJM MASTERMIND PBC/6X user manual

Atlas

Atlas MMK-KVM8 owner's manual