Black Box LWE121A User manual

BLACK BOX®

Quick Installation Guide

Wireless Ethernet Extender

Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)

FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax

724-746-0746 • Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence,

PA 15055-1018 • Web site: www.blackbox.com • E-mail: info@blackbox.com

Customer

Support

Information

March 2009

codes codes

LWE121A LWE121A-KIT

LWE121AE LWE121UK-KIT

LWE121UK

Page 2 724-746-5500 | blackbox.com

Chapter 1: Overview

About the Quick Installation Guide

This Quick Installation Guide is intended to guide professional installers to install

and configure the Wireless Ethernet Extender. It covers procedures to assist you in

avoiding unforeseen problems.

1. Overview

1.1 Introduction

The Wireless Ethernet Extender is a 2x2 outdoor access point. The LWE120A

operates at 2.4-GHz band. Ideally suited for SMB or hotspot networks, this

breakthrough innovation provides superior Wi-Fi network solutions at significantly

lower cost.

In addition, the easy-to-install Wireless Ethernet Extender is also a high-

performance last-mile broadband solution that provides reliable wireless network

coverage for outdoor broadband application.

Figure 1-1. Front view.

Page 3

724-746-5500 | blackbox.com

Chapter 1: Overview

Figure 1-2. Back view.

RJ-45 port Grounding point

Reset button

Figure 1-3. Bottom view.

Page 4 724-746-5500 | blackbox.com

Chapter 2: Preparing for Installation

2. Preparing for Installation

This chapter describes safety precautions and product information you have to

know. Read this chapter before installing the Wireless Ethernet Extender.

Professional Installation Required

Seek assistance from a professional installer who is well trained in RF installation

and knowledgeable in the local regulations.

Safety Precautions

To keep you safe and install the hardware properly, read and follow these safety

precautions.

1. If you are installing the Wireless Ethernet Extender for the first time, for your

safety as well as others’, please assistance from a professional installer who has

received safety training on the hazards involved.

2. Keep safety as well as performance in mind when selecting your installation

site, especially where there are electric power and phone lines.

3. When installing the Wireless Ethernet Extender, note the following things:

• Do not use a metal ladder;

• Do not work on a wet or windy day;

• Wear shoes with rubber soles and heels, rubber gloves, and a long-sleeved shirt

or jacket.

4. When the system is operational, avoid standing directly in front of it. Strong RF

fields are present when the transmitter is on.

Installation Precautions

To keep the Wireless Ethernet Extender well while you are installing it, read and

follow these installation precautions.

1. Users MUST use a proper and well-installed grounding and surge arrestor with

the Wireless Ethernet Extender; otherwise, random lightning could easily cause

fatal damage to the unit.

WARNING: EMD (Lightning) DAMAGE IS NOT COVERED UNDER

WARRANTY.

2. Users MUST use the power cord and PoE injector shipped in the box with the

Wireless Ethernet Extender. Using other options will damage the unit.

Page 5

724-746-5500 | blackbox.com

Chapter 2: Preparing for Installation

3. Users MUST power off the Wireless Ethernet Extender first before connecting

the external antenna to it. Do not switch from a built-in antenna to the external

antenna from WEB management without physically attaching the external

antenna onto the unit; otherwise, the Wireless Ethernet Extender might be

damaged.

What‘s Included

Your package should contain the following items. If anything is missing or

damaged, contact Black Box Technical Support at 724-746-5500 or

info@blackbox.com.

The LWE121A, LWE121AE, and LWE121UK packages contain the following items:

• (1) IEEE 802.11n Wireless Ethernet Extender

• (2) detachable 5-dBi antennas

• (2) pole-mounting rings

• (1) 24-VDC power cord and PoE injector

• (1) ferrite suppression core

• (1) grounding wire

• This printed quick installation guide

The LWE121A-KIT and LWE121UK-KIT packages contain:

• (2) IEEE 802.11n Wireless Ethernet Extenders

• (4) detachable 5-dBi antennas

• (4) pole-mounting rings

• (2) 24-VDC power cords and PoE injectors

• (2) ferrite suppression cores

• (2) grounding wires

• This printed quick installation guide

To download the user manual from the Web site:

1. Go to www.blackbox.com

2. Enter the part number (LWE121A) in the search box:

3. Click on the “Resources” tab on the product page, and select the document

you wish to download.

NOTE: Users MUST use the power cord and PoE injector shipped in the box with

the Wireless Ethernet Extender. Using other options will damage the unit.

Page 6 724-746-5500 | blackbox.com

Chapter 2: Preparing for Installation

Figure 2-1. Pole-mounting ring.

Figure 2-2. Power cord and PoE injector.

Figure 2-3. Ferrite suppression core.

Page 7

724-746-5500 | blackbox.com

Chapter 3: System Installation

3. System Installation

Connect up

1. The bottom of the Wireless Ethernet Extender is a movable cover. Grab the

cover and pull it back harder to take it out as the figure shown below.

Figure 3-1. Removing the bottom cover from the extender.

2. Plug a standard Ethernet cable into the RJ-45 port.

Figure 3-2. Plugging a standard Ethernet cable into the RJ-45 port.

3. Slide the cover back and press down the lock button to seal the bottom of the

Wireless Ethernet Extender.

Figure 3-3. Replacing the bottom cover.

Page 8 724-746-5500 | blackbox.com

Chapter 3: System Installation

Using the Grounding Wire

The extender has a grounding wire. Be sure to connect the extender, cables, and

PoE injector to earth ground properly during normal use to protect against surges

or ESD.

1. Remove the screw on the grounding point at the bottom of the Wireless

Ethernet Extender.

Figure 3-4. Grounding point on the extender.

2. Put the grounding wire on the grounding point at the bottom of the Wireless

Ethernet Extender. Then screw the grounding wire to tighten up.

Figure 3-5. Tighten the grounding wire.

3. Connect the grounding wire to earth ground.

Page 9

724-746-5500 | blackbox.com

Chapter 3: System Installation

Install the External Antenna

The Wireless Ethernet Extender provides two reverse SMA antenna connectors for

connecting the external antennas.

Figure 3-6. External antenna connectors.

1. Connect your external antennas to the SMA-type connectors on top of the

Wireless Ethernet Extender. For longer distance, we recommend using

higher-gain antennas to best suit the application.

Figure 3-7. External antennas connected to the extender.

WARNING: Users MUST power off the extender first before connecting the

external antennas to it. Do not power on the device without physically

attaching the antenna; otherwise, your extender might be damaged.

Page 10 724-746-5500 | blackbox.com

Chapter 3: System Installation

2. Bend the antenna to 90 degrees or 45 degrees.

90°

45°

Figure 3-8. Bend antenna.

3. You may turn one antenna 45 degrees to the left and the other 45 degrees to

the right. The tilted antennas couple together much less than if they are both

pointed in the same direction.

NOTE: Align the polarization of the antennas properly. Maximum signal strength

between bridges occurs when both antennas are using identical

polarization.

4. Tighten the connector joint clockwise to fix the antennas.

Figure 3-9. Tighten the connector clockwise.

This manual suits for next models

Table of contents

Other Black Box Extender manuals

Black Box

Black Box ServSwitch ACU2 01A-R2 User manual

Black Box

Black Box LR0304A-KIT User manual

Black Box

Black Box ACU7001A User manual

Black Box

Black Box IC569A User manual

Black Box

Black Box AC2000A User manual

Black Box

Black Box ServSwitch ACU1001A User manual

Black Box

Black Box ServSwitch ACU6001A User manual

Black Box

Black Box IC169A User manual

Black Box

Black Box LB532A-L User manual

Black Box

Black Box ServSwitch ACU6001A User manual

Black Box

Black Box ACX300-R2 User manual

Black Box

Black Box AC163A User manual

Black Box

Black Box LPR1111 User manual

Black Box

Black Box ACX2MT Series User manual

Black Box

Black Box ACX1MT Series User manual

Black Box

Black Box AVX-HDMI2-FO-HDB-KIT User manual

Black Box

Black Box AVS-HDB-WPTX User manual

Black Box

Black Box ACS2028A User manual

Black Box

Black Box ServSwitch ACU1022A User manual

Black Box

Black Box ACS2009A-R2-xx User manual

Black Box

Black Box AC550A User manual

Black Box

Black Box SERVSWITCH Series User manual

Black Box

Black Box Wizard DVI SRX User manual

Black Box

Black Box ServSwitch ACU3001A User manual

Popular Extender manuals by other brands

SY HDBT-60T installation guide

Appsys ProAudio

Appsys ProAudio ADX-16 user manual

Atlona

Atlona RS232 user manual

IDK

IDK OPF-TH1000-A user guide

Enable-IT

Enable-IT 824WP quick start guide

Worx

Worx Landroid RadioLink WA0864 Get started

TP-Link

TP-Link TL-WA730RE user guide

Camplex

Camplex CMX-HDMI-SFPL user manual

SC&T

SC&T HE03-4K user manual

Marmitek

Marmitek MegaView70 user manual

Samsung

Samsung SCS-26UC4 user guide

Foxun

Foxun SX-GES24 operating instructions

MuxLab

MuxLab 500771 Operation manual

foxunhd

foxunhd SX-AEX01 operating instructions

TERK Technologies

TERK Technologies LFIRX2 owner's manual

Devolo

Devolo Audio Extender supplementary guide

Edimax

Edimax EW-7438RPn V2 instructions

Shinybow USA

Shinybow USA SB-6335T5 instruction manual