Bitspower BP-VGLINK-OLED User manual

安裝方式/Installation/安装方式

VGA Block Link with OLED

V3/第三版

注意，跑水前，請先確認所有零件已安裝在正確的位置上，在不開主機，單開水泵的情况下，進行24小時的跑水測試，確保無漏水情况後再開主機，避免發生漏水而導致電腦零件的損壞。

注意，跑水前，请先确认所有零件已安装在正确的位置上，在不开主机，单开水泵的情况下，进行24小时的跑水测试，确保无漏水情况后再开主机，避免发生漏水而导致电脑零件的损坏。

Before filling in the water, please make sure all the components are installed correctly. To prevent any leakage which may damage the PC components, please perform a 24-hour leaking test

with only the pump connected to the power supply .

本公司保留對產品的設計更改以及解釋的權力，如有更動恕不另行通知，產品顏色與配件以實物為準。

本公司保留对产品的设计更改以及解释的权力，如有更动恕不另行通知，产品颜色与配件以实物为准。

Bitspower reserves the right to change the product design and interpretations. These are subject to change without notice. Product colors and accessories are based on the actual product.

牙　　規：G1/4"

輸入電壓：DC 5V~12V

顯示溫度：0~99°C(32~210.2°F)

工作電流：<20ma

牙　　规：G1/4"

输入电压：DC 5V~12V

显示温度：0~99°C(32~210.2°F)

工作电流：<20ma

Thread : G1/4"

Input Voltage : DC 5V~12V

Temperature : 0~99°C(32~210.2°F)

operate current : <20ma

水溫

Water temperature

水温

SATA端子

SATA

SATA端子

折線圖

Line Graph

折線圖

˚C

240 S

TEMP

80.6

˚F

240 S

122

192

TEMP

輕觸此按鍵，輕觸此按鍵3秒，進入模式切換狀態

Press and hold the button for three seconds in

order to switch the device's status.

轻触此按键，轻触此按键3秒，进入模式切换状态

安裝方式/Installation/安装方式

Before filling in the water, please make sure all the components are installed correctly. To prevent any leakage which may damage the PC components, please perform a 24-hour leaking test

with only the pump connected to the power supply .

本公司保留對產品的設計更改以及解釋的權力，如有更動恕不另行通知，產品顏色與配件以實物為準。

本公司保留对产品的设计更改以及解释的权力，如有更动恕不另行通知，产品颜色与配件以实物为准。

Bitspower reserves the right to change the product design and interpretations. These are subject to change without notice. Product colors and accessories are based on the actual product.

Step 1

拆開冷頭上的Link

Take apart the VGA link on the blcok.

拆开冷头上的Link

Step 2

安裝BP-VGLINK-OLED

Install the BP-VGLINK-OLED.

安装BP-VGLINK-OLED

M4x35 螺絲

M4x35 Screw

M4x35 螺丝

O圈

O-Ring

O圈

安裝方式/Installation/安装方式

VGA Block Link with OLED

Before filling in the water, please make sure all the components are installed correctly. To prevent any leakage which may damage the PC components, please perform a 24-hour leaking test

with only the pump connected to the power supply .

本公司保留對產品的設計更改以及解釋的權力，如有更動恕不另行通知，產品顏色與配件以實物為準。

本公司保留对产品的设计更改以及解释的权力，如有更动恕不另行通知，产品颜色与配件以实物为准。

Bitspower reserves the right to change the product design and interpretations. These are subject to change without notice. Product colors and accessories are based on the actual product.

V3/第三版

注意：Bitspower建議消費者使用蒸餾水、純凈水，加入Bitspower的染劑作為水冷液使用；如客戶自行

選購的水冷液導致電鍍層剝落、水道堵塞、水泵轉動不正常、水箱管破裂或密封圈變型以致漏水

等及其它不可抗力之問題時，消費者自行承擔相關產品責任。

未注水前，請勿啟動水泵電源。

注意：Bitspower建议消费者使用蒸馏水、纯净水，加入Bitspower的染剂作为水冷液使用；如客户自行

选购的水冷液导致电镀层剥落、水道堵塞、水泵转动不正常、水箱管破裂或密封圈变型以致漏水

等及其它不可抗力之问题时，消费者自行承担相关产品责任。

未注水前，请勿启动水泵电源。

Notice:

Bitspower recommends that consumers add the Bitspower dye to distilled water or puri-

fied water for their water-cooling liquid. If the consumer chooses different water-cooling

liquids, the resulting impurities may cause peeling of the coating on some of the hard-

ware, water channels blockage by built-up residue, improper operation of the water

pump, water tank tube breakage, and o-rings deformation leading to leakage. Any issues

related to the use of inappropriate water-cooling liquid will be the responsibility of the

consumer.

Do not turn on the pump if the reservoir is empty.

Before filling in the water, please make sure all the components are installed correctly. To prevent any leakage which may damage the PC components, please perform a 24-hour leaking test

with only the pump connected to the power supply .

本公司保留對產品的設計更改以及解釋的權力，如有更動恕不另行通知，產品顏色與配件以實物為準。

本公司保留对产品的设计更改以及解释的权力，如有更动恕不另行通知，产品颜色与配件以实物为准。

Bitspower reserves the right to change the product design and interpretations. These are subject to change without notice. Product colors and accessories are based on the actual product.

Before filling in the water, please make sure all the components are installed correctly. To prevent any leakage which may damage the PC components, please perform a 24-hour leaking test

with only the pump connected to the power supply .

本公司保留對產品的設計更改以及解釋的權力，如有更動恕不另行通知，產品顏色與配件以實物為準。

本公司保留对产品的设计更改以及解释的权力，如有更动恕不另行通知，产品颜色与配件以实物为准。

Bitspower reserves the right to change the product design and interpretations. These are subject to change without notice. Product colors and accessories are based on the actual product.

Table of contents

Other Bitspower Computer Hardware manuals