98. STORAGE, RETURN AND DISPOSAL
Storage
All Beinlich pumps are supplied with sealing plugs and
in suitable packaging for all destinations and modes of
transport to ensure optimum protection. The pumps should
always be stored in their original packaging. The units
must not be exposed to temperatures below -20°C or
above +60°C and must be protected from moisture and
its effects.
Return
1.
Only cleaned, medium-free pumps can be accepted by
Beinlich Pumpen for maintenance or repair. The pump
must therefore be properly cleaned by the customer
before being returned to prevent the risk of poisoning/
contamination by harmful, explosive and other high-
risk pumped media for humans and the environment.
2. If media have been conveyed whose residues with
atmospheric humidity lead to corrosion damage
or ignite on contact with oxygen, the pump must be
additionally neutralised and thoroughly cleaned with
anhydrous, inert gas to dry.
3. The return of the pump must always be accompanied
by a fully completed declaration of non-objection
(see section 14, page 14). All applied safety and
decontamination measures must be indicated. Pumps
for which this safety certificate has not been completed
and signed cannot be inspected or repaired for safety
reasons and will be returned uninspected at your
expense. The declaration of no objection can be
requested from Beinlich Pumpen or downloaded from
our website.
4. When returning the pump, it must be packed in
accordance with the applicable logistics standards
and sealed with sealing plugs.
Disposal
Beinlich actively promotes environmental awareness
and has an operational management system that meets
the requirements of ISO 9001:2015. The impact on the
environment and people should be minimised during the
production, storage, transport, use and disposal of our
products and solutions.
•
Collect rinsing liquid as well as residual liquid
and dispose of it in accordance with the statutory
provisions and regulations.
•
Wear protective clothing and protective mask/+
goggles if necessary.
Materials must be disposed of properly as follows:
•
Metal
•
Plastics
•
Grease and lubricants
•
Electronic components
•
etc.
When disposing of the materials, ensure that the waste-
relevant rules and regulations of the respective country of
destination are observed!
