BCM WIGO 800I User manual
WIGO800I Instructions
1 / 26
WIGO 800I Installation Manual
Your Best GSM & WiFi Phone Partner
BCM Communication Co., Ltd.
WIGO800I Instructions
2 / 26
Introduction
This is a start up manual for WIGO800I, a GSM-Wireless VoIP
Dual mode Phone of BCM. Before using this unit, some
configurations are required to make the phone work properly. Make
sure that DHCP server is available, and handsets can register itself to
AP correctly. Otherwise, you should setup the IP address of this unit
by yourselves. You can use any of your current GSM SIM card in this
unit. Thank you for choosing WIGO800I for your dual world
experience.
Owner’s Record
The MAC address is located inside battery compartment. Record
the MAC address in the space provided below. It may be required
whenever you contact your service provider. Or you can check it
inside the phone system by manual, please refer to the chapter
PhoneSettings.
Model No. : WIGO800I
MAC Address : _______________________
Dealer : ______________________
Limited Warranty
¾BCM warrants to you that, for a period of one year (the
“Warranty Period”), your equipment will be substantially free of
defects in materials and workmanship under normal use. Your
exclusive remedy and BCM’s entire liability under this warranty
will be for BCM at its option to repair or replace the product or
refund your purchase price less any rebates. This limited
warranty extends only to the original purchaser.
¾This product (including document, contents, and firmware of this
device) is provided “AS IS”. Except as required by applicable
law, no warranty of any kind, express or implied conditions,
representations and warranties, including but not limited to all
implied warranties and conditions of merchantability and fitness
for a particular purpose and non-infringement. BCM reserves
the right to make changes, improvements, revises or withdraw
to any of the product at anytime without prior notice.
¾If the product proves defective during the Warranty Period call
BCM technical support in order to obtain a return authorization
number, if applicable. If you are requested to return the product,
mark the return authorization number clearly. You are
responsible for shipping defective products to BCM.
WIGO800I Instructions
3 / 26
¾This warranty does not apply if the product (a) has been
altered, except by BCM, (b) has not been installed, operated,
repaired, or maintained in accordance with instructions
supplied by BCM, or (c) has been subjected to abnormal
physical or electrical stress, misuse, negligence, or accident. In
addition, due to the continual development of new techniques
for intruding upon and attacking networks, BCM does not
warrant that the product will be free vulnerability to intrusion or
attack.
¾To the extent not prohibited by law, BCM is liable for any loss or
damaged data, any revenue or profit, or for special, incidental,
consequential, indirect or punitive damages, regardless of the
theory of liability ( including negligence), arising out of or
related to the use of or inability to use the product ( including
any software) howsoever caused. The foregoing limitations will
apply even if any warranty or remedy provided under this
agreement fails of its essential purpose. Some jurisdictions do
not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion
may not apply to you.
On Copyrights
Copyright © 2007 BCM. All rights reserved.
¾Other products and brands mentioned herein maybe
trademarks or registered trademarks of their respective owner.
¾Unauthorized changes or modifications to this device may void
your authority to operate the equipment.
¾This product is protected by certain intellectual property rights of
Microsoft Corporation. Use or distribution of such technology
outside of this product is prohibited without a license from
Microsoft or an authorized Microsoft subsidiary.
¾This product includes Skype Version V1.1.0.20. This product
uses the Skype API but is not endorsed or certified by Skype.
¾IP TV, IP Radio, films, pictures and other materials may be
copyrighted. Unauthorized recording of such materials may
violate copyright laws.
¾Use, transfer, or distribution of part or all of this product in any
form without the prior written permission of BCM is prohibited.
¾Certain features, such as Skype, MSN, IP TV, IP Radio are
branded services provided by third parties. BCM does not
guarantee such services or warrant their continued availability.
Note for Use
¾The availability of particular products may vary by region. Screen
shots in this manual may be different from the actual displays in
the supplied software.
¾Emergency call is available to use while there is not a SIM Card
inserted.
¾GSM radio and WLAN radio are not operating simultaneously.
WIGO800I Instructions
4 / 26
¾The LCD of your device is designed with precision
technology. However, in some cases, individual pixels may
remain lit or may not light at all. Also, the brightness of the
display may appear inconsistent, depending on the angle
of view. Such anomalies are caused by the nature of the
LCD and do not indicate a malfunction. Please note that
BCM does not guarantee a replacement or refund for such
cases. Do not expose the LCD to direct sunlight for
prolonged periods of time. It may result in a malfunction.
Do not store your device in areas subject to sunlight, such
as near windows, and be careful when using outdoors.
¾Please take few minutes to run-through this manual,
especially pay attention on [Note], they can be very
useful and important notice for you to use this phone.
Do not skip these notice.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by
one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's authority to
operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
WIGO800I Instructions
5 / 26
Specification & Key Features
GSM & Wi-Fi Dual Standby
GSM Quadri-Band 850/900/1800/1900 Supported
802.11b/g WLAN Support
Frequency ․FCC -- Channel 1~11 Supported
․CE -- Channel 1~13 Supported
․JP -- Channel 1~14 Supported
SMS Supported
MPEG-4, WMV, MP3 Support
Skype / MSN Installed
○
！This product uses the SkypeAPI but is not endorsed or certified by Skype.
Hot SpotAuto-Login
Battery Power
‧ GSM + WLAN Dual Standby Time up to 50 Hours
‧ Talking Time up to 3 Hours
○
！Actual talk time vary according to different operating environments. Battery talk
and standby times are estimates only and depend on network configuration, signal
strength, features used, battery age and condition, charging practices, temperatures
to which battery is exposed, and many other factors. Please note that the amount of
time a phone is used for calls, Skype, or MSN will affect its standby time. Likewise,
the amount of time that the phone is turned on and in standby mode will affect its talk
time.
2.2" 240 x 320 pixels with 65k color TFT-LCD
Dimension : 121 x 46.5 x 19.5mm
4.8oz
Battery: LI-ION 1500mAh
Memory 32MB Flash / 128MB SDRAM
○
！ Please note that actual free memory may vary due to phone pre-configuration.
T Flash supported
Stereo Earphone Jack
miniUSB Charging Mechanism
Multiple Languages -- ․English ․Spanish
Support G.711, G.729 Codec
Support RFC3261 SIP V2 / RFC2327 SDP
3-way Conference Call
Support VOD (Video On Demand)
Web Camera Streaming
IE Browser Installed
Phone Book & Speed Dial
Web GUI
Software Auto-Upgrade through Internet / Auto-Provisioning
○
！ Please note that local variations may apply.
Support 64/128-bit WEP Key
Support WPA-PSK Encryption
WIGO800I Instructions
6 / 26
WIGO800I Instructions
7 / 26
WIGO800I Instructions
8 / 26
WIGO800I Instructions
9 / 26
Make Calls
You can make calls by selecting from Phonebook or dial the number
directly. There are 2 phone call service types for you to make a voice call –
GSM or SIP.
1 To start a voice call directly, enter the phone number in the standby
mode, including the area code if you want to make GSM calls.
The phone calls service type will show at the left top of the window, you
can press the center key to switch between GSM and SIP calls.
For international calls, Press the asterisk key ＊ twice for the “+ "
character before a country code.
To make a call from Phonebook, press right soft key to the contact
list, or you can also enter the first letter of the name to the search field, a
matching contacts will be listed.
Scroll to the desired name and press , there will be options of call
type for you to select, choose one--SIP or GSM—and press make call key
again.
2 Press to call the number.
3 Press to end the call, or deny an incoming call.
Continued
➭➭➭
WIGO800I Instructions
10 / 26
SIP Settings
Make sure you already have a SIP account pre-set in the unit by your
service provider. If you do not have a SIP number, please contact your
service provider.
[Hint] Menu ÎPhone Settings ÎSIP Settings
If you want to show your name to people you call, Press left soft key to
edit your “Display Name”, use center key to save and then return.
[ Note ]
1 You can use SIP type just same as ordinary GSM call, however you must
have an active internet connection since the SIP call dialing till end of the
call.
2 For both way to make calls, You can select Option during a call
connected, there are several line options available. You can make any line
action anytime by selecting from the line options list.
3 To change the volume during a call, You can use the navigation pad to
adjust Volume.
Continued
➭➭➭
Table of contents
Other BCM IP Phone manuals
