Barco FL40 series User manual

Other manuals for FL40 series

3

Table of contents

Popular Projector manuals by other brands

iEmmet

iEmmet MP-312 user manual

Epson

Epson VS400 Specifications

Sony

Sony VPL-HS10 Marketing Specifications & Features manual

Sony

Sony VPL-HW65ES Quick reference manual

Toshiba

Toshiba TLP-791U Specifications

Philips

Philips LC1341 Declaration of conformity

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB operating instructions

NEC

NEC NP600S EDU Specifications

BenQ

BenQ SH753P user manual

Eiki

Eiki EK-623U series quick start guide

Epson

Epson PowerLite Pro Cinema 6020UB user guide

Epson

Epson PowerLite Home Cinema 705HD user guide

Christie

Christie LHD700 user manual

Navitar

Navitar FX instruction manual

InFocus

InFocus LitePro 560 user guide

Sony

Sony SRX-R815P operating instructions

Vivitar

Vivitar DP1500 X specification

Acer

Acer C20 Series manual

Barco FL40 projector quick guide

Turning on

Press buttons (P1) or (R1) indicated in images above. The projectors power button will start blinking

blue light. The power on sequence might take a minute or two. When the light is constantly showing

blue, the projector is on.

IF THE PROJECTOR POWER WAS COMPLETELY OFF (ELECTRIC CORD NOT CONNECTED), READ THE

MANUAL SECTION 5.2.

Turning off

Press buttons (P1) or the “O”button right next to (R1) indicated in images above. Keep the button

pressed for approximately 4 or 5 seconds. During this time in the LCD screen of the projector a

power-down image is shown indicating the time how long to continue pressing the button should be

still continued. When the projector is powered down and cooling down, the light on the power

button (P1) will first blink white and then turn constantly white.

IF IT IS NECESSARY TO REMOVE THE POWER CORD OF THE PROJECTOR FOR SOME REASON

(NORMALLY THIS IS NOT AT ALL NECESSARY), DO NOT REMOVE THE POWER CORD OR TURN OFF

ELECTRICITY BEFORE THE PROJECTOR HAS BEEN POWERED DOWN FOR A COUPLE OF MINUTES!!

P1

Changing projector source

Changing the projectors source from for example DVI to HDMI or back, you have to use the remote

control to do that. Press “Input”and select your source with the remote’s selection buttons. The

source indicator in the lower corner of the screen should disappear shortly when you have your

source showing something (for example the DVD player is on). Press “Input”button again to make

the display screen go away.

NOTE! The remote control can be used within the Magnetically Shielded Room (MSR). Just point the

remote towards the projector inside the MSR by the vault door. You can see your selections on the

screen. If the selection screen does not automatically go away after your work, press “Back”button

on the remote. Pressing “OSD”(On Screen Display) will also take away the selection screen, but you

have to remember to press it again to bring the display back when you need it.

NOTE! If you need your own HDMI source, for example, just change the HDMI cable to your own

source behind the projector. Unlike the old projector, this one has only one HDMI input.