■Do not use this appliance with a programmer, timer switch or any other part
that turns on the appliance automatically.
■Always observe the maximum mark when filling the jug with ingredients.
If you process liquids in the blender jug, the maximum volume is 1.5L.
If you process liquids in the storage bottle, the maximum volume is 0.7L. Do
not exceed the maximum volume indications, especially when you process
ingredients that tend to foam.
■Pay increased attention when handling hot liquids, because they may release
steam, or they could spray and cause burns. Allow hot liquids to cool down to a
temperature of at least 40°C before pouring them into the blender jug.
■Do not leave the appliance in continuous operation for longer than 3 minutes.
Before turning it on again, allow it to cool down for at least 10 minutes. When
processing harder foods or thick liquids, do not leave the appliance in
continuous operation for longer than 1 minute.
■The appliance is equipped with a thermal fuse protecting the motor from
damage in case of overload. If the appliance shuts off as a consequence of the
motor being overloaded, disconnect it from the power socket and allow it cool
for at least 30 minutes. Then you can put into operation again.
■If ingredients stick to the blade assembly or the inside walls of the blender jug,
turn the appliance off and unplug it from the power supply. Make sure that the
blade assembly has stopped rotating.
■Take the blending jug assembly off the motor u nit and turn it over so that the
blade assembly points upwards. Remove the blade assembly and clean the
removed parts using a plastic spatula. Assemble the appliance, plug the power
cord into a power socket and continue blending.
■When handling the blade assembly, be very careful not to injure yourself on its
sharp cutting edge. This applies especially when removing the blade assembly
from the blend in g jug, when emptying the Jug and when cleaning.
■While the appliance is running, prevent fingers, hands or objects from contact
with the blade assembly.
■The included blending Jugs are not intended for heating food in a microwave
oven.
■Always turn off the appliance and disconnect it from the power socket if you will
not be using it and if you will be leaving it without supervision, before
assembly, disassembly, replacing accessories and before cleaning or moving
it.
■Check that the motor unit is turned off, disconnected from the power socket
and that the rotating parts have come to a complete stop before removing the
blending jug assembly from the motor unit.
■Clean it according to the instructions in chapter “Cleaning and maintenance”.
Do not submerge the motor unit or its power cord in water or any other liquid or
wash these parts under running water.
