Bacharach H-10 PRO User manual
How to clean the pump on an H10 Pro
1. Remove the two Phillips-head screws that are located inside the probe storage area.
Caution: DO NOT loosen or remove the two screws located on the back slotted area of the chassis
2. Disconnect the battery and remove chassis from the case, invert and lay it on the workplace table or
desk.
3. Remove the four Torx screws from the bottom of the pump using a T6 Torx driver
4. Disassemble the two plates and rubber valve plate from the pump
5. Remove the rubber valve plate and clean with a clean dry cotton swab and a can of Keyboard
Duster.CAUTION: When using the Keyboard Duster, make sure you hold the rubber valve plate to
avoid blowing it from the bench top.
6. Re-assemble in reverse order and check pump for proper operation
Other manuals for H-10 PRO
1
Other Bacharach Security Sensor manuals
Bacharach
Bacharach MVR-300 User manual
Bacharach
Bacharach GDC-350 User manual
Bacharach
Bacharach Leakator Jr. User manual
Bacharach
Bacharach H-10 PRO User manual
Bacharach
Bacharach MGS-150 User manual
Bacharach
Bacharach H25-IR PRO User manual
Bacharach
Bacharach N2O Portable Monitor User manual
Bacharach
Bacharach Informant Leak Detector User manual
Bacharach
Bacharach Tru Pointe 2100 Instruction Manual
Bacharach
Bacharach H-10PM User manual
