AWW INDUSTRIES Spark User manual

Instruction Manual

Warning:

USB charging cable

3.7V Lithium

rechargeable battery

Blade B

Blade A

Motor (Forward)

Blade B

Blade A

Motor (Forward)

Motor (Reverse)

Body

Fly Side Trimming

Direction Lever

Forward/Backward Trimming

Flip Button

Power Switch

Turning Trim

Acceleration Lever

Throttle trim

Speed Mode Button

Power Indicator

POWER

Package Diagram

• Follow instructions included in this package.

Do not assemble without adult supervision.

• Product contrains small parts that may be

hazardous to children.

• Only charge product with the charger provided in

this package.

• Disconnect product before cleaning the charger.

•Do not recharge non-rechargeable batteries.

• Only charge batteries under adult supervision.

• Do not mix old and new, or different types of

batteries. Promptly remove depleted batteries.

• Do not short circuit or disassemble batteries.

• Remove batteries if the product will not be used

for a long time to prevent battery damage.

• Do not bump or drop the product or remote

control.

• Do not touch rotating parts to avoid injury.

• Only clean product with a clean, soft cloth.

• User is responsible to ensure product will not

cause harm to self or others, or damage to

personal property. Manufacturers and distributors

do not take any responsibility.

• Please retain packaging and instruction manual for

future reference.

Figure A Figure B

Figure C

USB indicator

USB charging cable

Remote Control Battery Installation

Charging the Quad’s Battery

Remove the remote control’s battery cover and install 4 AAA

batteries (not included) according to the correct polarity. Reattach

the battery cover and tightly fasten the screws.

NOTE: Before charging, remote battery from the quad.

To charge the battery:

1. Remove the lithium battery as shown in Figures A and B.

2. Plug the USB charging cable into the USB port of your computer. The indicator light on the cable will turn on.

3. Connect the cable to the battery connector. The USB light will turn off indicating the quad is now charging.

4. When finished, the USB light will again turn on. Disconnect and reinstall the battery into the quad. Charging

time is appoximitely 90 minutes.

Battery Cautions:

• If battery becomes hot during charging process, stop immediately to avoid battery damage or possible fire.

• Do not set battery next to high heat or flammable materials. If battery starts to emit strange odor, deformation,

discoloration, or other anomolies, stop using this battery.

• If battery leaks, avoid contact with skin and eyes. If contact is made, immediately rinse with cold water and

seek medical attention. Discontinue use of battery.

• Only use charger provided with product to charge battery.

• Do not put battery into fire, microwave over, or pressure tank.

• Do not use solvents, industrial alcohol, or other flammable substances to clean product or charger.

• Product is composed of plastics, electronic components, and batteries. Follow local garbage collection

requirements when discarding.

NOTE: See diagram for correct polarity. Do not mix old and new

batteries.

Sidefly

Right

Sidefly

Left

Forward

Backward

Turn Right

Turn Left

Descend

Ascend

POWER

Syncing the Quad and Remote

Flying the Quadcopter

1. Connect the battery to the quad. Turn the power switch on and place the quad on flat ground. The quad’s

lights will be flashing rapidly.

2. Make sure the acceleration lever on the remote is at its lowest position. Turn the controller on, and you will

hear it beep twice. The quad’s lights will begin flashing more slowly. Push the acceleration lever all the way up

and then back down. The remote will beep once, and the the lights on the quad will stay lit. The quad and

remote are now synced. You are ready to fly your quad!

Note: The blue lights on the quad are the forward direction

Flight Tips:

• Use the slow speed mode for flying inside. Avoid obstacles, pets, and people.

• Use the fast speed mode for flying outdoots. Do not fly in windy or rainy weather.

Flight Warnings:

• Do not fly quadcopter in inclement weather.

• Flying quadcopters within 3 miles of an airport is prohibited.

• Quadcopter’s range is 200 feet. Do not fly quad outside of this range. Exceeding range may cause damage to

your quad.

• Stand 10 feet behind quad when taking off.

• For best control when flying, it is recommended the pilot always stays behind the quad when possible.

Push accelerator lever up,

quad will ascend.

Push accelerator lever

down, quad will descend.

Basic Flying Maneuvers:

Push direction lever up,

quad will fly forward.

Push direction lever down,

quad will fly backward.

Push accelerator lever left,

quad will turn left.

Push accelerator lever

right, quad will turn right.

Push direction lever left,

quad will fly left.

Push direction lever right,

quad will fly right.

RightLeft

Turn left

Turn right

Backward

Forward

Right Roll

Left Roll

Front Flip

Back Flip

POWER

Press the speed button to

switch to high gear

Trimming the Quadcopter

Gently push the acceleration lever until the quad is about 3 feet off the ground. If the quad favors any

direction, you can trim the motors so it flies with more balance.

Note: When the quad is flying an inch off the ground, it is affected by blade vortex and becomes

unstable. Fly at a higher altitude to better trim the quad.

NOTE: Fly quad to 5 feet in the air to safely do flips.

Press the Flip Button.

Remote control will beep.

Press the Flip Button.

Remote control will beep.

Flip Mode:

Push direction lever up,

quad will flip forward.

Push direction lever

down, quad will flip

backward.

When quad spins left, press

right button until it flies straight.

When quad spins right, press

left button until it flies straight.

When quad leans forward, press

back button until it flies straight.

When quad leans back, press

forward button until it flies

straight.

When quad leans left, press

right button until it flies straight.

When quad leans right, press

left button until it flies straight.

If the quad cannt take off, you can reset the quad to fix this.

Switch the speed to high speed. Hold both levers down and to

the left then release. The indicator will rapidly flash. Once the

indicator is lit, the correction is complete.

Push direction lever left,

quad will roll left.

Push direction lever left,

quad will roll left.

After enough practice, try the following exercises:

Fixed rotation (turning)

Landing in designated

locations (point landing)

Problem Cause Solution

Straight ahead - turn left - forward - turn left -

forward - left, practice flying a square pattern.

Forward - backward - to the left -

to the right to complete a cross

action

Flight Exercises

Troubleshooting

Quad turns on, but

can’t fly

Quad shakes violently

Quad takes off to one

side

Quad flies out of

control

Quad cannot fly

faster

Quad lands too fast

and crashes

Pilot quickly pulled back the

acceleration lever

Slowly lower the acceleration lever when

landing

1. Remote or quad have poor power

supply.

2. Remote and quad are not synced.

1. Rotor deformation

2. Hollow shaft is bent

1. Rotor deformation

2. Motor damage

3. Aircraft was not flat when synced

with remote

1. Rotor rotation speed is too slow

2. Quad battery is low

1. Slowly push up on accelerator lever

2. Recharge battery

1. Fly quad within 200 foot flight range

2. Sync your quad independently, one by

one

1. Quad is beyond control range

2. Multiple quads were synced at the

same time

1. Replace corresponding wing

2. Replace motor

3. Resync quad and remote on flat

surface

1. Replace corresponding wing

2. Replace hollow shaft

1. Reinstall fully charged batteries.

2. Resync remote and quad.

01 Upper Body 02 Lower Body 03 Battery Cover 04 1 Set of Blades

05 Forward Motor 06 Reverse Motor 07 Lithium Battery 08 Circuit Board

Inventory and Product Parameters:

10 Green Light

09 Blue Light 11 USB Charger

Parts List

Notes:

1. Control range will be affected when the remote control runs low on battery power.

2. If battery power is too low, the quad will have trouble taking off.

3. If quad appears damaged, promptly repair. Do not fly near trees, people, obstacles, or in high winds

to avoid damage.

4. Remove the batteries during long term non usage to prevent battery leakage and damage.

5. Avoid high altitude or high impact collisions in order to prevent damage.

Inventory Checklist: 1x Quadcopter, 1x Remote Controller, 1x 3.7V Lithium Battery, 1x

USB Charging Cable, 1x Instruction Manual, 4x Extra Blades

Quad Battery: 3.7V Lithium Battery Remote Range: About 200 feet

Flight Time: 5 1/2 minutes

Remote Control Battery: 4x 1.5V AAA batteries

(not included)

Charging Time: About 90 minutes TIP: Before each charge, wait 10-15 minutes, until the

battery cools to extend battery life.

AWW INDUSTRIES™ is an innovative division of DGL Group, Ltd.

Other trademarks and trade names are those of their respective owners.

AWW INDUSTRIES,

195 Raritan Center Parkway, Edison, NJ 08837.

Specifications, colors and contents may vary from illustrations.

WARNING: This product may

contain a chemical known to

the State of California to cause

cancer, or birth defects, or

other reproductive harm.

PROP 65 WARNING

Manufactured in China.

Batch Ref: XXXX

Model Number: XXXX

Conforms to safety requirements of ASTM, FCC, & CPSIA.

WARNING:

CHOKING HAZARD-Small parts.

Not for children under 3 years.

Tested to comply with FCC standards.

FOR HOME OR OFFICE USE.

This device complies with part 15 of the FCC

Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful

interference and

(2) This device must accept any interference

received, including interference that may cause

undesired operation.

BATTERY WARNING:

• Do no mix alkaline, standard (carbon zinc), rechargeable (nickel hydride) batteries.

• Do not mix old and new batteries.

• Non-rechargeable batteries should not be recharged.

• Rechargeable batteries should be removed from the appliance before being charged.

• Rechargeable batteries should be charged under adult supervision only.

• Exhausted batteries should be removed.

• The supply terminals should not be short-circuited.

• Only batteries of the same or equivalent type are recommended to be used.

• Batteries should be inserted with the correct polarity.

Table of contents

Other AWW INDUSTRIES Quadcopter manuals

AWW INDUSTRIES

AWW INDUSTRIES AW-QDR-ELT User manual

Popular Quadcopter manuals by other brands

dji

dji MAVIC 2 PRO quick start guide

Autel Robotics

Autel Robotics EVO II Dual 640T quick guide

Carson

Carson X4 NANO instruction manual

Attop

Attop W80 Instructions for use

Alias

Alias 6608 owner's manual

Reely

Reely Drone Copter 2-in-1 operating instructions

Hubsan

Hubsan FPV X4 H107D instruction manual

Falcon

Falcon S2-210 quick start guide

Kaiser Baas

Kaiser Baas KBA15007 user guide

Denver Electronics

Denver Electronics DCH-261 instructions

Craig

Craig INTERCEPTOR owner's manual

Odyssey

Odyssey TURBO RUNNER manual

IMAGINARIUM

IMAGINARIUM droni stream instructions

Hubsan

Hubsan X4 Pro FPV instruction manual

AR.Drone

AR.Drone Parrot VSM user guide

Walkera

Walkera QR X900 quick start guide

dji

dji Phantom 2 Vision + user manual

HobbyZone

HobbyZone Zugo instruction manual