Audiovox AS 9076N User manual
128-8496
1 of 4
Page1
Model AS 9076N
Owner’sManual
Remote Start
Upgrade Module
FEATURES :
♦Remote Start Safety Control Switch
♦ Selectable Automatic Timed Start Mode (2 Or 4 Hours Selectable intervals)
♦On-Board Start Relay
♦ On-Board Accessory Relay
♦On-Board Ignition 1 Relay
♦On-Board Ignition 2 Relay
♦Ignition 2 Relay Selectable On or Off During Cranking
♦On-Board Parking Light Relay
♦ Ignition 3 / Shock By-Pass / GM VAT Output (relay required)
♦Tach Signal Learning Circuitry
♦Two ( + ) and Two ( - ) Safety Shutdown Circuits
♦Alarm By-Pass Outputs
♦ Selectable Steady or Flashing Parking Lights for Run Indication
♦ Selectable 10 or 15 Minute Run Time
♦ Factory Keyless Upgrade Inputs (Allows Starting From Factory Keyless Entry
Unit)
♦4 Auxiliary Outputs To Allow Control Of A Factory Alarm
♦Diesel Glow Plug Preheat Mode select
CAUTION!
Be certain that the vehicle is outdoors before using this or any
remotevehicle startingdevice. Arunning engineproduces danger-
ous carbon monoxide fumes which can be harmful or fatal if pro-
longedexposure occurs. DONOTremote start thevehicleif thecar
isgaraged.
128-8496
2 of 4
Page2
This Remote Start Upgrade unit is designed to be added to an existing remote
control keyless entry system, or remote alarm system.
Because it is an upgrade unit it can be wired to operate from any unused button(s)
from your keychain transmitter. Please check with your installing dealer for which
transmitter button is connected to your remote start unit and, if you require a
single, double, or sequential press of the button(s) to operate your system.
SAFETY(RedHandled)CONTROLSWITCH
The control switch allows you to temporarily disable the remote starting function
of your Remote Start System. To disable the unit, move the red handled control
switch to the off position.
The control switch also allows you to select between automatic 2 hour start up
or 4 hour start up when using the automatic start up timer mode. The factory
preset start up time for this mode is every 4 hours. To select between 2 or 4 hour
start up timer:
1.Begin with the control switch in the on position
2.Turn the ignition switch on then off
3.Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to
select a 2 hour start timer. After 10 seconds expire, the parking lights will
flash 2 times confirming that the two hour start cycle is set. Or, within 10
seconds move the control switch off, on, off, on, off, on, off, on (4 switch
cycles) to select a 4 hour start timer. The parking lights will flash 4 times
confirming that the 4 hour start timer is set.
REMOTESTARTINGTHEVEHICLE
The System WILL NOT start the vehicle if any one of the following conditions
exists:
1.The Vehicle Hood Is Opened.
2.The Gear Selector Is In Any Gear Other Then Park.
3.The Brake Is Depressed.
4.The Safety Control Switch Is In The Off Position.
CAUTION! Be certain that the vehicle is outdoors before using this or any remote
vehicle starting device. A running engine produces dangerous carbon monox-
ide fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT
remote start the vehicle if the car is garaged.
128-8496
3 of 4
Page3
To Remote Start The Vehicle:
Press and release the proper button or combination of buttons on your keychain
transmitter to activate the remote start system. The vehicle will start and
remain running for the pre-programmed 10 or 15 minutes. As a visual indica-
tion, the parking lights will flash or turn on dependent on the programming setup
by your installation center.
When you arrive at your vehicle, unlock the vehicle by pressing and releasing the
unlock button of your keychain transmitter or by use of the vehicle key. Enter the
vehicle and turn the ignition key to the on position.
CAUTION! Do not turn the key to the start position. This will cause the starter motor
to engage with the already running engine which could result in dam-
age. Step on the brake pedal to disengage the remote start unit. The
vehicle will continue to run on it's own power.
NOTE: The engine will stop running before the expiration of the pre-pro-
grammed run timer if you complete any of the following:
1.Pressing the proper button or buttons of your keychain transmitter while run-
ning under control of the remote start system will turn the vehicle off.
2.Depress the brake pedal.
3.Open the hood.
4.Move the red handled control switch to the off position.
5.Race the engine to above 4000 RPM.
OPERATINGONAUTOMATIC STARTUPTIMER MODE
The system has the ability to automatically start the vehicle every 2 or 4 hours
over a 48 hour period. This feature is especially useful in cold climates where
the only means to keep the engine and engine fluids warm is to periodically start
the engine.
CAUTION! Be certain that the vehicle is outdoors before using this or any remote
vehicle starting device. A running engine produces dangerous carbon mon-
oxide fumes which can be harmful or fatal if prolonged exposure occurs.
DO NOT remote start the vehicle if the car is garaged.
128-8496
4 of 4
Page4
FUNCTIONSETTING CHART
To be completed by installer
Lights Steady Pulse
Run Time 10 Min. 15 Min.
TOBEGINTHEAUTOMATIC STARTUPTIMER
1.Turn the ignition key on then off.
2.Within 10 seconds, activate the RF start command two times.
The parking lights will flash 4 times indicating the timed start mode is activated.
The vehicle, on a 2 or 4 hour interval basis, will automatically start, run
for the pre-programmed time (10 of 15 minutes), and then shut off. This will
continue for 48 hours.
NOTE: The automatic start up timer can also be initiated from the keychain
transmitter.
To do this:
1.Start the vehicle using the keychain transmitter by pressing and releasing the
remote start transmitter button'(s).
2.Shut off the vehicle using the keychain transmitter by pressing and releasing
the remote start transmitter button'(s).
3.Within 10 seconds of step 2, activate the RF start command two times.
The parking lights will flash 4 times indicating the timed start mode is activated.
CANCELINGTHEAUTOMATIC STARTUPTIMER
To cancel the automatic start up timer do one of the following;
1. Start the vehicle manually with the use of the ignition key and depress the
brake pedal.
2. Remote start the vehicle using your keychain RF transmitter.
And then
3. Shut off the vehicle using the keychain RF transmitter.
©2009 Audiovox Electronics Corp., 150 Marcus Blvd. Hauppauge, N.Y. 11788 128-8496
Table of contents
Other Audiovox Remote Starter manuals
Audiovox
Audiovox PRO9246FT3 User manual
Audiovox
Audiovox Pursuit PRO-9675FT4 User manual
Audiovox
Audiovox APS620 - Prestige Remote Start User manual
Audiovox
Audiovox Prestige APS-55LRa User manual
Audiovox
Audiovox Prestige APS-45 User manual
Audiovox
Audiovox Pursuit PRO-9776 User manual
Audiovox
Audiovox Prestige APS-57 User manual
Audiovox
Audiovox Prestige Platinum APS-57C User manual
Audiovox
Audiovox Prestige APS-55TWT User manual
Audiovox
Audiovox Prestige APS-57a User manual
Audiovox
Audiovox Pursuit PRO 9246FT3 User manual
Audiovox
Audiovox Prestige Platinum+ APS 675 User manual
Audiovox
Audiovox Prestige APS-55TW User manual
Audiovox
Audiovox Patinum APS-997 User manual
Audiovox
Audiovox AS 9075a User manual
Audiovox
Audiovox Pursuit PRO-9276 User manual
Audiovox
Audiovox Auto Security AS-9501a User manual
Audiovox
Audiovox Auto Security AS-9151N User manual
Audiovox
Audiovox Pursuit PRO-9276 User manual
Audiovox
Audiovox AS-9050 User manual
