Audiovox SP-6CDP User manual
OWNER’’
S MANUAL
MODEL : PAV-6CDP
6 COMPACT DISC AUTO CHANGER
1
* Tracks from 6 CDs stored in the disc magazine can be selected and
played.
* Horizontal, vertical, angled and suspended installation.
* Do not install the unit in a location where it may be
subjected to :
- direct sun or other forms of excessive temperature.
- excessive heat.
- fluid, rain or moisture.
- excessive dirt or dust.
- excessive vibration.
* This unit is designed to be operated on a 13.8 volt DC
negative ground electrical system only.
Notes on CDs
* A defective or soiled disc stored in the disc magazine can
cause sound to drop out during play.
* Always handle a disc by holding its inner and outer edges.
* Do not touch the surface of the
unlabeled side of the disc.
* Do not stick paper or tape etc.
onto a disc.
2
* Do not expose the discs to direct
sunlight or excessive heat.
* Clean the discs before inserting
them into the disc magazine.
Always clean a disc from center
outward with a cleaning cloth.
* Never use solvents such as benzine or alcohol to clean a disc.
* You cannot play an 8cm(3 inch) CD even with the specially
designed adapter.
Notes on the disc magazine
* Do not leave the disc magazine in a place subject to
excessive temperature or humidity.
* Do not insert more than one disc per slot.
* Do not drop the disc magazine.
3
1. * Pull out the slot by pulling
the part with finger.
* With the label side up, insert
a CD all the way
6 discs, one in each slot
* Push slot and close it.
3. Insert the magazine firmly
(which has been taken out
of the unit) with the
mark visible on the top side.
* Press the eject button and pull
out the disc magazine.
2. 4.
4
Precautions
Select the mounting location very carefully by referring to the following points
* Make sure that there is not a fuel tank, wiring or piping on the other side of
the mounting surface.
* Make sure that the installation of the unit will not hinder the movement of the
trunk lid or interfere with the spare tire etc.
* Use only the supplied mounting kit for a safe and proper installation.
Supplied mounting kit
BRACKET X 2 Double-sided
tape X 1
TAPPING
SCREW X 4
Adhesive
label X 1
WASHER
SCREW X 4
PLATE
BRACKET
BOLT X 4 NUT X 4
5
Installing the unit
Mounting angle setting lever
Be sure to adjust Mounting Angle
Setting Lever(A) to appropriate
angle; 0°for horizontal, 22.5°
angle, 45°angle, 67.5 angle, 80°
angle, or 90°for vertical.
Removing the transport
screws
Find the 3 transport screws at the
bottom of the unit, which lock the
unit’s mechanism during transport.
Remove these screws before
installation and attach the supplied
adhesive labels ④over the holes.
Retain these screws and replace
them in the original positions if the
unit is transported for service or
maintenance.
6
After adjustment, be sure to
attach the Double side Tape .
Note
Do the same procedure on
the other side of the unit.
Horizontal installation
Construction
Removing temporarily
Making holes on the carpet
Completion
Note
About parts numbers ❶❷
❺❻❼❽,refer to page 4.
angled installation
Be sure to turn the mounting
angle setting dial to the 45。
position.
7
Vertical installation
1. Construction
2. Removing temporarily
3. Making holes on the carpet
4. Completion
Note
About parts numbers ❶❷❺
❻❼❽, refer to page 4.
8
Suspended installation
When installing the unit in the
trunk under the rear window
shelf, observe the following.
- Make sure that the unit is
suspended horizontally.
- Select the mounting location
carefully so that the unit does
not hinder the movement of
the torsion bars of the trunk
lid.
- Make sure that there is nothing
on the other side of the
mounting location before drilling
the holes.
- Select the correct size screw to
avoid damaging the vehicle rear
deck.
1. Construction
2. Making holes
3. Completion
Note
About parts numbers ❶❷❺,
refer to page 4.
9
When connecting, run the
supplied connecting cable and
connect to Audiovox model
PAV-9 as illustrated here.
Caution
Make sure to disconnect the ground
wire terminal of the car battery before
making a connection in order to
prevent short circuiting.
Note
Use only the supplied connecting
cable.
For complete operation instructions,
refer to pages 18,19 and 20 in the
PAV-9 owner’s manual.
System
Usable Disc
Power Source
Weight
Dimensions(WXHXD)
Frequency Response
S/N Ratio
Channel Separation
T.H.D
Output Power
Note
The design features and/or specifications are subject to change
without notice.
6 CD Change system
Compact disc (12cm)
DC 13.8V Negative ground
1.9kg(4.2 lbs)
254×63×157mm(10”×2.5”×6.2”)
20~20kHz
90dB
70dB
0.03dB
700 mV
General
Other manuals for SP-6CDP
1
This manual suits for next models
1
Table of contents
Other Audiovox CD Player manuals
Audiovox
Audiovox Rampage ACC-52 Programming manual
Audiovox
Audiovox CE142AR User manual
Audiovox
Audiovox ACC-40 User manual
Audiovox
Audiovox CE146B User manual
Audiovox
Audiovox CE101A - annexe 1 User manual
Audiovox
Audiovox 1285400 User manual
Audiovox
Audiovox CE248 User manual
Audiovox
Audiovox CE240 User manual
Audiovox
Audiovox CE101B User manual
Audiovox
Audiovox ACC-40 User manual
Audiovox
Audiovox CE-145B User manual
Audiovox
Audiovox SP10CDP User manual
Audiovox
Audiovox CE201R User manual
Audiovox
Audiovox CE270 User manual
Audiovox
Audiovox CE215 Technical manual
Audiovox
Audiovox CE1705 User manual
Audiovox
Audiovox SP-6CD User manual
Audiovox
Audiovox CE211R Technical manual
Audiovox
Audiovox SP-11CDS User manual
Audiovox
Audiovox CDA1361 User manual
