Audiovox AVXMTGHR1DA User manual

Audiava

I!Biioooooo•••••••••~••••••••eooooooiii!E

:::>

c:=:::J

EEEJ(

)

EEEl

1111111111111

DIIDD

IDIIDII

_~.,.~

'---

...__

Important Notice

Installation

headrest products require careful planning and preparation. Be extremely careful

with seats that have airbags built into them. Keep wiring away from any air bag wiring (usually

identified by yellow connectors and yellow wire jackets). Damage to air bag wiring can result

personal injury to vehicle occupants. If you have any questions regarding wire routing or

installation

avehicle, pleasecontactAudiovoxTechnical Supportat 1-800-225-607

When connecting power and ground

a mobile video installation, insure that the ACC wire is

fused at the point where it is connected to the vehicle ACC wiring. Failure to do so can result

damage to the vehicle ifa short circuit develops between the vehicle connection point and the

mobilevideo product.

An LCD panel and/orvideo monitormay be installed

a motorvehicle and visible to the driverif

the LCD panel or video monitor is used for vehicle information, system control, rear or side

observation or navigation. If the LCD panel or video monitor is used for television reception,

video or DVD play, the LCD panel orvideo monitor must be installed so that these features will

onlyfunction when the vehicle is

"park"orwhen the vehicle's parking brake

applied.

An LCD panel or video monitor used for television reception, video or DVD play that operates

when the vehicle

gearorwhen the parking is not applied must be installed to the rear

the

driver'sseatwhere itwill notbe visible, directlyor

indirectly, to be operator

the motorvehicle.

Licensed underoneormore

thefollowing patents:

Patent NOS. 7,245,274, 6,899,365and 6,678,892

FEATURES

•

Digital Thin Film Transistor (TFT) Active Matrix Liquid Crystal Display (LCD) Monitor

• Built-in DVD Player

• Last position memory for DVD player

• FourAudio I Video Source inputs "DVD,

AV,

AUX and Media (USB/SO)"

• USB 2.0 port I SD Card Reader input

• On Screen Display (OSD) for control

picture quality and functions

• Full function remote control

• Plays DVD, CD and MP3 discs

• IR headphone (optional)

SPECIFICATIONS

Type

Resolution

Pixels

Operation Temperature

Storage Temperature

Backlit life

Video Display System

Headphone Audio Output

Video Output

TFTActive Matrix LCD

480x234

336,960

-113°

(0-

45° C)

-4-

149° F

(-20-

65° C)

20,000 Hours

NTSC I PAL I AUTO

0.03W @ 32 ohms

1.0Vp-p @ 75 ohms

12VDC

Power Source

Dimension (L x W x H) 147mm x 275mm x 200mm

?in x 10.8in x 7

.Bin

Specifications subject to change without notice.

MATERIAL TO USE

THIS PACKAGE:

1) AVXMTGHR1

System Monitor with DVD Player (AVXMTGHR1DA)

pc)

EEI!J( ti!i!l

)EEEI

NOTE: The AVXMTGHR1 DA monitor has been designed

with interchangeable covers. The headrest cover as

supplied is covered with shale colored vinyl. Black vinyl

and pewtervinyl can replace the shale colored vinyl.

NOTE: Headrest cables are included with the headrest DVD player and the headrest monitor.

1) Remote Control

(P/N 136-5433)-

pc)

I Power Cable, 8 Pin Din to 3 RCA (Red)

(P/N 112-4309)-(1pc)

Black Vinyl Headrest Cover

(P/N 126-1377)-(1pc)

';,.,J)

7) Shrink Tubing, Black

(P/N 138-1495 )-(2pcs)

0""---

___..)

Adapter Cable

(P/N 112B3227)-(1pc)

OUT Cable, 8 Pin Din to 3 RCA (Green)

(PIN 112-4310)-(1pc)

6) Pewter Vinyl Headrest Cover

(P/N 126-1378)-(1pc)

8) Support Tube Adaptor Box

(P/N 170-0170)-(1

Tray)

111111

llllll

HEADREST COVER REPLACEMENT:

NOTE:

desired, replace the headrest cover before installing the headrest

the vehicle.

1. Using a Philips screwdriver, unscrew the two Philips screws and lift the bottom edge

the monitor upward.

Unscrew

Philips

Screws

2. Remove the velcro tabs securing the headrest cover.

Remove

Velcro

Tabs

Replace the headrest cover with the desired color and secure the headrest cover by

re-attaching the velcro tabs.

4.Piace the monitor cable into the space

the right side of the headrest and lower the

monitor into position to align the two Philips screws with the screw holes

the headrest.

Close the screen and press the PUSH button to secure the screen.

5.Tighten screws

VEHICLE PREPARATION

1) Decide on the system configuration and the options that will be installed.

2) Read the manual and get familiar with the electrical requirements and

connections.

3) Decide on the mounting locations and methods

mounting the products that

will be connected to the AVXMTGHR1 DA.

4) Prepare the vehicle by removing any interior trim necessary to gain access to

the vehicle's wiring as well as all areas where interconnecting wire harnesses

will

located. This manual will only focus on the installation

the

AVXMTGHR1 DA Monitors

the supplied configuration.

NOTE: The Master Monitor should be installed

the passenger position most

used.)

5) Locate an accessory power source +12VDC (ACC) present when the ignition

key

the accessory and run positions.

OVDC

should be present when the

ignition key is

the OFF position), and a good ground. Generally, these

wires can be found at the ignition switch or fusebox.

NOTE: Ensure that the accessory power is fused at the source. Failure to do so

may result

vehicle wiring damage.

6) Run the wiring harnesses throughout the vehicle as necessary. (Refer to the

Wiring Diagrams on page 8). Be sure, that all the wiring is protected from sharp

edges and is routed

such a manner that it will not be pinched when it is fully

installed. Be sure to leave enough slack

the wiring at each component to

allow sufficient working room. Be sure to leave enough slack

the monitor

cables to allow the headrest to move up

down, and seat movement.

7) Install the headrests:

Remove vehicle's original headrests.

Insert appropriate support tube adaptors

vehicle post guides (if needed).

Hold the headrest above the seat and insert the two cables into the vehicle

support guides. Make sure that the headrest

the correct position (display

facing the rear).

Route the cables through the seat back and out the bottom

the seat while

pulling the cables to remove the slack. Be sure to leave enough slack

the

monitor cables to allow the headrest to move up or down.

8) Connect all the components together (electrically) and verify proper operation

all the system functions.

9) If 2 AVXMTGHR1 DA's are installed

a vehicle, set one unit to IRTA and the

other unit to IRTB. See page

for instructions.

Wireless

Modulator

The AVXMTGHR1DA

equipped with a built-in wireless

Modulator, that

allows you to listen to the DVD audio signal by tuning your vehicle's radio to the

selected frequency, (CH1 87.7MHz, CH2 88.1 MHz, CH3 88.5MHz, CH4

88.9MHz, CH5 106.7.1MHz, CH6 107.1MHz, CH7 107.5MHz, CH8 107.9MHz).

This feature

accessed by using the

transmitter buttons

the remote

(FMM ON/OFF, and CH.l\NNEL SELECT).

Whenever the

Modulator is on, broadcast reception on the vehicles radio will

be poor. Switching the

Modulator off will allow normal radio reception.

NOTE:

certain areas where there are a large number

radio stations (e.g.

large cities, urban areas), the reception of the

signal may not be satisfactory,

resulting

static, distorted sound or signal bleed thru from strong local radio

stations. This

not a defect

the product, but the result

a stronger local radio

station overpowering the wireless

transmitter

your headrest monitor. Under

these conditions use

wired or wireless headphones

recommended.

AVXMTGHR1

WIRING DIAGRAM

Headrest Monitor

RED

-------------------------

+12V (ACC

r-u-------;?-~.:......;,J'---,wu...---.J'

.........

·----•

Ground-

~--1

Power Cable, 8 Pin Din to 3 RCA (Red)

(P/N 112-4309)

GREEN

Video Out Yellow

~......__.=====-...:U21D

Aud1o

Out Left

Wh1te

I=I::::::J..I_,._

___._.......__ICil-:=!11

Audio Out Right Red

AV OUT Cable, 8 Pin Din to 3 RCA (Green)

(P/N 112-4310)

AVXMTGHR1 DA CONTROLS AND INDICATORS

DIAGRAM (FRONT VIEW}

POWER/SOURCE

PLAY/PAUSE

STOP

SCREEN RELEASE

Card

NOTE:

Insert the

Card with

the card contacts facing

up and toward the user.

lllioooooo•••••••••l•••••••••ooooooilll

I I

"'·

)r-~

'L...--

IIIIDIIII

....

L,.;

PULL DOWN

L....

L-.

(BOTTOM VIEW}

0 0

EEE~EEE

aaaaaaaaaa

(FRONT VIEW MONITOR OPEN}

LCD PANEL

VOLUME+/NEXT

SYSTEM MENU

VOLUME-/PREVIOUS

IR HEADPHONE

TRANSMITTER LENS

IR SENSOR

REMOTE CONTROL OPERATION

NOTE:

The remote control has a battery installed with a pull tab to prevent battery

discharge. Remove the pull tab before attempting to use the remote.

Battery Replacement

Depress the tab (1) and slide the battery holder (2) out

the direction

the arrow.

Install one CR2025 battery. Make sure that the proper polarity(+

or-)

is observed.

Slide the battery holder into the remote control until it locks.

(1)

CR2025

Tab (1)

Battery

Holder(2)

Remote Control Function Description

5 6

10/0

Protective PullTab

Clear Plastlc

CR202S

\MV..~f+----

L------tt--14

7 8

Other manuals for AVXMTGHR1DA

Table of contents

Other Audiovox Car Receiver manuals

Audiovox

Audiovox ACD-23 User manual

Audiovox

Audiovox ACD-16 User manual

Audiovox

Audiovox Rampage ACD-88 User manual

Audiovox

Audiovox GC-600 User manual

Audiovox

Audiovox VM9413 User manual

Audiovox

Audiovox Prestige P-57S User manual

Audiovox

Audiovox 128-6210A User manual

Audiovox

Audiovox Prestige P153B User manual

Audiovox

Audiovox Sirius SIR-PNP3 User manual

Audiovox

Audiovox Prestige Home Theater Sytem User manual

Audiovox

Audiovox Jensen MP5620 User manual

Audiovox

Audiovox Rampage ACD-25 Programming manual

Audiovox

Audiovox Prestige P-25 User manual

Audiovox

Audiovox CE250 User manual

Audiovox

Audiovox VME 9114 TS User manual

Audiovox

Audiovox ADUO-100-MAZ Troubleshooting guide

Audiovox

Audiovox AVD400 - AVD 400 - DVD Player User manual

Audiovox

Audiovox Jensen MP5720USB User manual

Audiovox

Audiovox VME 8013 - User manual

Audiovox

Audiovox VME 9125 NAV User manual

Audiovox

Audiovox AV1410 User manual

Audiovox

Audiovox Rampage ACD-21 User manual

Audiovox

Audiovox AV-428V Programming manual

Audiovox

Audiovox PAV-8000D Guide

Popular Car Receiver manuals by other brands

Motorola

Motorola VWA63 Service manual

Nextar

Nextar D3201 instruction manual

Alpine

Alpine CDE-163BT owner's manual

Pioneer

Pioneer DEH-P645R installation manual

Axxera

Axxera XDMA7600 Installation & owner's manual

XM OnyX quick start guide

Sound Storm

Sound Storm STM93R user manual

Soundstream

Soundstream VIR-5000 owner's manual

Avson

Avson MKT Platform user manual

Sony

Sony MEX-1HD - Audio Library System operating instructions

Pioneer

Pioneer DVH-P500UB Operation manual

JVC

JVC KD-AHD69 Specifications

Blaupunkt

Blaupunkt SANTIAGO CR 87 operating instructions

Sony

Sony CDX-4160 - Cd Receiver operating instructions

XFIRE AUDIO

XFIRE AUDIO BMW42S owner's manual

VDO

VDO CD 2253 datasheet

Volvo

Volvo 13 84 580 installation instructions

ZENEC

ZENEC ZE-160DVD instruction manual