Atmor Enjoy Operating instructions
www.atmorusa.com
Hot Water on Demand
Installation and Operation Guide
Enjoy
Electric Tankless Water Heater
Full Shower System
6kW/240V
Instant water heater provides endless supply of hot water
while signicantly conserving energy and water
o
2
Page
Safety Guidelines ..........................................................................................................................3
Technical Information.....................................................................................................................4
Plumbing........................................................................................................................................5
Mounting........................................................................................................................................6
Installation Procedure................................................................................................................ 7-8
Wiring ............................................................................................................................................9
Starting the System .....................................................................................................................10
Operation Guide .....................................................................................................................11-12
Care and Maintenance ................................................................................................................13
Troubleshooting...........................................................................................................................14
Table of Contents
3
Important Safety Guidelines
SAVE THESE INSTRUCTIONS
1. Safety Guidelines
Read this manual thoroughly before attempting to install the instant water heater.
Failure to follow the safety instructions in this manual may cause damage to the unit,
and could also result in property damage, personal injury, or loss of life.
Failure to comply with the safety, installation or operating instructions voids the
product warranty.
The product manufacturer and the product distributor will not be liable for any damages
or injury because of failure to comply with the installation and operating instructions
specied in this manual or because of improper use.
Never attempt to install, disassemble, inspect or repair, disassemble or service the water
heater without rst shutting off all power to the unit by means of the circuit breaker on the
main electrical panel.
The water heater must be installed by a licensed electrician and in compliance with all
national, state, provincial and local electrical and building regulations.
Always contact your local authorized distributor for service.
2. Safety – Important Notes
.
•For power supply connection use 10 AWG or larger wires suitable for at least 194°F (90°C).
•The heater must be installed by a professional technician and according to the installation
instructions.
•The heater must be grounded.
•The heater must be connected to a dedicated circuit breaker on the main electrical panel.
•The plumbing installation must be completed before the electrical installation.
•The plumbing installation requires metal pipes or reinforced hoses that can withstand
pressure up to 101 psi (7 bar).
•To ensure proper operation, the water supply ow rate must be at least 4.35 psi (0.3 bar).
•Do not install the heater where it may be subjected to direct sunlight, rain, splashing water,
or freezing temperatures.
•This unit is intended for heating water only. Do not attempt to use the unit for heating any
other kind of liquid.
Before connecting the product to a public power network, consult your local power supply
authority to ensure the power network meets the stated requirements.
4
Technical Information
Electrical Specications
Enjoy
6 kW
Heating elements 1
Watts 6,000
Kilowatts 6 kW
Voltage 240 V
Circuit breaker amperage 1 x 30 A
Cable size (minimum) 3 x 10 AWG
Plumbing Specications
Minimum water ow to activate unit 0.47 gpm
Working pressure 4.35 psi - 101 psi
Tested pressure 203 psi
Water connections 1/2" NPT
Physical Dimensions
Height Width Depth Weight
15 inch (381 mm) 8½ inch (215 mm) 2¼ inch (55 mm) 4 lb 3 oz (1.8 kg)
Parts and Accessories
o
Shower head - Air Flow
A. Indicator light
B. Heating level selector:
0/Low/High
C. Hot water outlet
D. Cold water inlet
E. Reinforced pressure-
resistant hose
F. Hose and shower head
handle
G. Tap for water supply
to heater
5
Plumbing
01 02 The top of the heater should be at least 5 ft
(1.5m) above the oor.
The plumbing installation
must be completed before
the electrical installation.
05
0403
The plumbing installation requires pipes or
reinforced exible hoses that can withstand
pressure to 101 psi (7 bar) rated for high
temperature applications.
Residential plumbing
systems with unstable
pressure or pressure
above 72.5 psi (5 bar)
require the application of a
pressure stabilizer valve,
set to
58–72.5 psi (4–5 bar).
The shower head should be attached
to the slider rail at a comfortable
height for users.
06 Before proceeding to the electrical installation, run water through the
unit for several minutes to ush out any air bubbles from the water line.
While water is running, inspect all ttings and connections for leaks.
6
Mounting
01
03
02
04
The unit must be installed in an upright position with the
water inlet and outlet at the bottom.
The heater has two mounting options (Page 8, Figures 4 and
5) – either attach the backplate of the heater to the wall, or use
a slide wall-mount bracket. Using the backplate or the bracket
as a template, mark the mounting points on the wall.
The mounting surface
must be solid and secure.
Drill holes, and insert screw anchors that are suitable for screws
at least 1 inch in length.
7
Assembly Instructions
01
07 0908
02
04
06
03 05
Remove the appliance
covers (Figure 2).
Make sure the unit is level.
Mount on the wall, and
secure using 1 inch
screws.
Make sure power to the unit is shut
off by means of the dedicated circuit
breakers on the main electrical panel.
Insert the power cable into
the heater (Figure 3).
Do not connect to the
terminal block.
Connect the water hose
to the entry point of the
heater, and connect the
supplied accessories to
the water outlet.
Do not obstruct the
water outlet. Use
only accessories
supplied with the heater
(Figure 6).
Connect the power cable to the terminal
block within the unit. (Figure 7)
Caution: The heater must be
grounded.
Make sure all wire connections are secure.
Secure the power cable
with the designated
clamp (Figure 7).
Replace the front
cover onto the unit and
reattach it with 2 screws
(Figure 2).
Restore power to the unit
by means of the dedicated
circuit breakers on the
main electrical panel.
8
32
4 5
1
6 7
A
B
o
o
Washer
Option 2Option 1
Line 1
Ground
Line 2
Water
Filter
9
Electrical Diagram
1 2 3 4
5 6
6
1. Terminal block
2. Thermostat
3. Microswitches
4. Rotary switch
- Setting 0: Off
- Setting 1: Low 2.2 kW
- Setting 2: High 6 kW
5. Indicator light
6. Heating elements
L1
L2
E
240V
10
Starting the System for the First Time
01
03
02
04
Open the water tap (G)
to a gentle ow. Slowly
increase the ow until
the appliance lamp/s
light up. Wait 15 to 20
seconds for hot water to
ow out. Then adjust the
water temperature by
increasing/decreasing the
ow.
When nished using the
appliance, turn the selector
to the 0 setting
and close the tap (G).
Select the desired heating level (B):
Setting 0: Off
Setting 1: Low
Setting 2: High
Select the desired heating
level (B).
o
A. Indicator light
B. Heating level selector:
0/Low/High
C. Hot water outlet
D. Cold water inlet
E. Reinforced pressure-
resistant hose
F. Hose and shower head
handle
G. Tap for water supply to
heater
This manual suits for next models
1
Table of contents
Languages:
Other Atmor Water Heater manuals
Atmor
Atmor 100 Series Operating instructions
Atmor
Atmor HOTAP Operating instructions
Atmor
Atmor Thermo Pro2 Series User manual
Atmor
Atmor InLine-3.0 User manual
Atmor
Atmor Platinum User manual
Atmor
Atmor Europe InLine 800 Series Operating instructions
Atmor
Atmor New User manual
Atmor
Atmor Super 900 User manual
Atmor
Atmor AT900-04 User manual
Atmor
Atmor INLINE 900 User manual
Popular Water Heater manuals by other brands
Kenmore
Kenmore 153.582400 Use & care guide
Applimo
Applimo Edel AIR Installation and operating instructions
STIEBEL ELTRON
STIEBEL ELTRON Eltronom SHU 5 S Operating and installation instructions
clage
clage E-Mini Series Operating and installation instructions
Toyotomi
Toyotomi Oil Miser OM-180 installation manual
Bradford White
Bradford White EF Series Service manual
Eccotemp
Eccotemp 40-H Use & care manual
Dimplex
Dimplex ECSd125-580 Installation and user instructions
Dux
Dux 32FCR6N installation manual
Toyotomi
Toyotomi Oil Miser OM-148 (Type D) Operation and maintenance instructions
Noritz
Noritz N-132M Owner's guide and installation manual
TESY
TESY GCV7/4S 10047 Instructions for use and maintenance
