8. Wear proper apparel. Loose clothing,
gloves, neckties, rings, bracelets, or
other jewelry may present a potential
hazard when operating this machine.
Please keep all apparel clear of the
machine.
9. Don’t overreach. Keep proper footing
and balance at all times when
operating this product.
10. Always disconnect the machine from
the power supply before servicing or
changing accessories.
11. Check for damage. Check your tool
regularly. If part of the tool is damaged
it should be carefully inspected to
make sure that it can perform its’
intended function correctly. If in doubt,
the part should be repaired. Refer all
servicing to a qualified technician.
Consult your dealer for advice.
12. Keep away from flammables. Do not
attempt to operate this tool near
flammables or combustibles. Failure to
comply may cause serious injury or
death.
13. Do not start tool while it is resting on
materials. Always turn tool on
BEFORE coming in contact with
material surface.
14. Do not set tool down until it has come
to a complete stop.
15. Always check to make sure that trigger
lock is not engaged before plugging
tool in.
16. Keep hands clear of cutting edges and
all moving parts.
17. Protect others in work area from
debris such as chips and sparks.
Provide barriers and shields as needed.
18. Secure work. Use a clamp, vise or
other practical means to hold your
work securely, freeing both hands to
control the tool.
19. Use the right tool for the job. Do not
use a tool or attachment to do a job
for which it was not intended. Do not
alter a tool.
20. Use proper accessories. Using
accessories no recommended may be
hazardous. Be sure accessories are
properly installed and maintained. Do
not defeat a guard or othe safety
device when installing an accessory or
attachment.
21. Remove all adjusting keys and
wrenches. Make a habit of checking
that adjusting keys, wrenches, etc. are
removed from the tool before turning
it on.
22. Guard against electric shock. Prevent
body contact with grounded surfaces
such as pipes, radiators, ranges, and
refrigerators. Hold your tool by
insulated, non-metal grasping surfaces.
Use a Ground Fault Circuit Interrupter
(GFCI) to reduce shock hazards.
23. Avoid accidental starting. Be sure your
tool is turned off before plugging it in.
Do not use a tool if the power switch
does not turn the tool on and off. Do
not carry a plugged-in tool with your
finger on the switch.
24. Do not force tool. Your tool will perform
better at the rate for which it was
designed. Excessive force only causes
operator fatigue, increased wear and
reduced control.
25. Do not abuse cord. Never carry your
tool by its cord or unplug it by pulling
the cord from the outlet. Pull the plug
rather than the cord to reduce the risk
of damage. Keep the cord away
from heat, oil, sharp objects, cutting
edges and moving parts.
26. Maintain tools carefully. Keep handles
dry, clean and free from oil and
grease.Periodically inspect tool cords
and extension cords for damage.
Refer all service to a qualified technician.
27. Store idle tools. When not in use,
store your tool in a dry, secure place.
Keep out of reach of children.
2
