anko 42788591 User manual
Introduction
Installation Instructions
User Instructions
1. This light set is designed for use OUTDOORS in an open (unshaded) location.
1. Remove all packaging before use and dispose of safely.
2. Ensure there are no pipes or mains cables immediately underneath, then fix the solar
panel assembly to the ground by the anchor spike.
2. Do not position or place near barbecues, heaters or any other direct sources of heat.
3. The solar panel should be located where sunlight can fall directly on the panel.
Shadows from buildings, trees, walls/hedges and similar objects should be avoided if
possible as these will reduce performance.
4. Try to avoid locations where light from other sources (e.g. streetlights, floodlights etc.,)
may affect the PIR sensor. This product is designed only to illuminate in dark
conditions, and may not operate if light reflects on the panel.
5. This product can be left outside in rain, but should not be exposed to water jets or
immersed. For optimum lifespan, the solar panel should be stored indoors during extreme
weather conditions (prolonged snow and frost).
The solar light consists of a solar cell, a rechargeable battery and LED lights. All these are
preassembled. During the day time, light from the sun charges up the batteries. At night,
the energy stored in the batteries is used to power the light. No other power or connections
are required. The length of time the light stays on is dependent on how much sunlight has
been received during the day.
3. Turn the ON/OFF switch at the bottom to “ON”.
4. Place the product at the desired locations. Ensure the cables are routed so that they
do not present a tripping hazard.
5. Press ‘MODE’ switch on solar panel to select function: ‘Steady on’ or ‘Flashing’.
The battery is non-replaceable. DO NOT attempt to replace it.
This product is designed for use OUTDOORS ONLY .
The light set is constructed with non-replaceable bulbs. DO NOT attempt to replace any
of the bulbs in the light set.
Battery Replacement
Bulb Changing
Warning
●
Remove all packaging before use.
●
This product is not a toy, keep out of reach of children.
●
This product has small parts, which may pose a choking hazard if detached.
Keep away from fire and sources of heat.
The end point of the ground stake is sharp. Please do not allow children to play with
the anchor spike.
●
●
●
Some condensation may form inside the unit or solar panel in cold conditions. This is
normal and can be ignored.
●
SOLAR POWERED 200 LED
BLUE ICICLE LIGHTS
These instructions are for your safety. Please read through them thoroughly
before use and retain for future reference.
Assembly diagram:
Keycode: 42788591
Direct sunlight is required to charge the battery.
1
2 3
Other anko Outdoor Light manuals
Popular Outdoor Light manuals by other brands
Lindby
Lindby 9949029 Intended use
HEPER
HEPER DOGO Side LW6048.585-US Installation & maintenance instructions
HEPER
HEPER LW8034.003-US Installation & maintenance instructions
Maretti
Maretti VIBE S 14.6080.04.A quick start guide
BEGA
BEGA 84 253 Installation and technical information
HEPER
HEPER MINIMO Installation & maintenance instructions
LIGMAN
LIGMAN BAMBOO 3 installation manual
Maretti
Maretti TUBE CUBE WALL 14.4998.04 quick start guide
Maxim Lighting
Maxim Lighting Carriage House VX 40428WGOB installation instructions
urban ambiance
urban ambiance UQL1273 installation instructions
TotalPond
TotalPond 52238 instruction manual
Donner & Blitzen
Donner & Blitzen 0-02661479-2 owner's manual