2
3
to antenna
hand tighten nuts
INSTALLATION
DURING MOUNT
PROTECTIVE CAP
DO NOT REMOVE
evenly and torque
nuts (4) to
22Nm (16.2lb-ft)
to a vertical pipe of diameter 48-115mm
(1.9-4.5").
The mount also provides adjustment in the
ranges of ±25°fine elevation and
±180°(±10°fine) azimuth.
experienced personnel Andrew installation
practices.
unsafe installation
responsibility for the results of improper or
Andrew disclaims any liability or
maintenance and condition of equipment.
personnel to verify proper installation,
inspected once a year by qualified
personnel. antenna systems should be
instructions have been written for such
Notice
The installation, maintenance, or removal of
antenna systems requires qualified,
Description
This antenna consists of a 0.2-metre(20cm)/
0.3-metre (1ft)/ 0.6-metre (2ft) reflector,
radome, feed and offset tower mount.
The mount is designed to attach the antenna
When fitting
Apply loctite (8)
to threads
before fitting
56
7*
7* 4
10
10
Visit our Web site at www.andrew.com or contact your local Andrew Wireless Solutions representative for more information.
102222
03
Bulletin
Version Rev EREStatus
1
2
102222
BRE01
Bulletin
RevStatusModel Version
Version RevStatus
0.2m(20cm), 0.3m(1ft) & 0.6m(2ft)
ValuLine Antenna Mount
1 of 2page
Installation Instructions A CommScope Company
GRE
03
Andrew Institute offers installation training.
Andrew Wireless Solutions
© 2008 CommScope, Inc. All rights reserved.
Andrew Wireless Solutions is a trademark of CommScope. All trademarks identified by® or ™ are registered trademarks or trade-
marks, respectively, of CommScope. This document is for planning purposes only and is not intended to modify or supplement any
Other Europe: +44 592 782 612
U.K.: 0800 250055
or 1-888-235-5732
U.S.A., Canada, Mexico: 1-800-255-1479
Customer Service 24 hours
specifications or warranties relating to Andrew Wireless Solutions products or services.
www.andrew.com
Notice: Andrew disclaims any liability or responsibility for the results of improper or unsafe installation, inspection, maintenance, or removal practices.
Aviso: Andrews no acepta ninguna obligacion ni responsabilidad como resultado de practicas incorrectas o peligrosas de instalacion, inspecci6n, mantenimiento o retire.
Avis : Andrew decline toute responsabilite pour les consequences de procedures d'installation, d'inspection, d'entretien ou de retrait incorrectes ou dangereuses.
Hinweis: Andrew lehnt jede Haftung Oder Verantwortung fur Schaden ab, die aufgrund unsachgemaBer Installation, Uberprufung, Wartung Oder Demontage auftreten.
Atencao: A Andrew abdica do direito de toda responsabilidade pelos resultados de praticas inadequadas e sem seguranca de instalacao, inspecao, manutengao ou remocao.
Awertenza: Andrew declina eventual! responsabilita denvanti dell'esecuzione di procedure di installazione, ispezione, manutenzione e smontaggio improprie o poco sicure.
2
1
0.3m (1ft) Application
(Single Pole version shown)
