Step 1 :If there’s a strong wind
blowing, park your vehicle with the
nose facing into the wind.
Step 2 :Undo the two securing
catches and lift the lid.
Step 3 :After you’ve lifted the lid a
little, the gas struts will kick into
action and open the tent fully.
Step 4 :Pull the compression elastic
down and secure by positioning
around the base of the tent canvas.
Step 5 :Remove ladder bag and pole
bag from inside the tent.
Step 6 :Remove poles from inside the
bag.
Step 7 :Place pole into lower tube
and then hook onto canvas eyelet.
Step 8 :Remove ladder from bag.
Step 9 :Slot ladder onto catch and
secure. Note, additional ladder
brackets can be specified (or
ordered) and installed on the sides
for side entry.
Step11 : The light switch is located
on the side of the frame (RHS).
Move the mattress slighly and you
will notice the switch together with
the USB ports.
Step 10 :Place pole bag into ladder
bag, and store in secure place.
V 06_16
page 1
EXPEDITION TENT
Tel: +27 21 703 3028
WWW.ALU-CAB.COM
Step12 : To connect power, you will find the power lead inside the shoe pocket
of your tent. Connect the Anderson plug into the supplied socket on the bottom
right hand side of the tent. Insert the 12V power plug into the closest
convenient power source.
