Alfano ADSMAG User manual
Copyright 2005 Alfano, S.A. Tous droits réservés. 1
ADSMAG
Manual ( N)
Firmware 0.1
Serial
Be preserved
1
0
0
0
Copyright 2005 Alfano, S.A. Tous droits réservés. 2
INSTALLATION
•It consists of 6 L Ds, 4 buttons, the external dimensions are
133,5x90x40mm, weight 275gr.
•The ADSMAG is equipped with a magnetic sensor ref. A1301
•Batteries : Type 2xAA
The four L Ds above the screen are activated by running the fastest time
achieved.
The two L Ds on the sides are activated by running the best partial.
DESIGNED FOR RENTAL
MAG
Copyright 2005 Alfano, S.A. Tous droits réservés. 3
Power On
Press the button on the bottom right, the
system is activated on the main page.
Backlig t
Depending on the setting in the S TUP
DISPLAY, the Alfano is active in several ways :
• "OFF" : Alfano the comes on without
backlight.
• "MAN" : the Alfano activates the
backlight :
o To activate : press the "ON", then
adjust the light intensity.
o To not activate : press the "OFF" or do
nothing for 3 seconds.
•"1-9" : The backlight automatically turns
on ALFANO.
Finally, the Alfano is positioned on "HOM ".
•Measurer status battery
•Measurer memory available
•Icon backlight
Copyright 2005 Alfano, S.A. Tous droits réservés. 4
Turn Off
From the main page, press the button on the
bottom right.
CIRCUIT, Configuration
From the main page, press the button on the
bottom left.
For t e visualization and t e logical recording of t e data, it is necessary,
before using t e ALFANO in race, to configure t e morp ology of t e
track.
-With the arrow « » at the top, choose the number of magnetic
strips installed on the circuit.
-With the arrow « » down, choose which band Magnetic must
start the stopwatch.
-Press on « OK » to finish the configuration of the circuit.
In the following example : configuration of a circuit with three magnetic
stripes with the departure timing from the second magnetic stripe.
This figure shows a circuit with a
magnetic stripe.
Copyright 2005 Alfano, S.A. Tous droits réservés. 5
Press the arrow above to add a second
magnetic stripe.
Press the arrow above to add a third
magnetic stripe.
Press the arrow down to select the
starting point of the timing of the second
magnetic strip, then press on « OK » to
finish the configuration of the circuit.
Note : this circuit will be in memory until
you change the morphology.
Windows race & Setting Led
From the main page, press the button at
the top right.
Then press on « C oice » to display
windows race (layout). Currently, there
are 12 windows to choose from.
Copyright 2005 Alfano, S.A. Tous droits réservés. 6
Press Setup to set the
maintenance of the lap time, the
brightness of the backlight and
L D. ach "Layout" is numbered to
facilitate the choice, this figure
with the word «Confirm» appears
only a few seconds. Press the
button « Confirm » to choose,
even if this word is no longer
visible on the screen.
The windows of racing
Race « 1 »
•Lap time
•Best ( best lap )
Race « 2 »
•Lap time
•Difference on the lap
•Difference on partial
Race « 3 »
•Lap time
•Nr of laps
•Difference on the lap
•Difference on partial
Copyright 2005 Alfano, S.A. Tous droits réservés. 7
Race « 4 »
•Lap time
•Nr of laps
•Difference on the lap
Race « 5 »
•Lap time
•Nr of partial
•Difference on the lap
Race « 6 »
•Lap time
•Nr of laps
Race « 7 »
•Lap time (R V RS )
•Nr of laps
•Difference
Race « 8 »
•Lap time with partial
ACCUMULAT D
•Nr of laps
•Difference
Copyright 2005 Alfano, S.A. Tous droits réservés. 8
Race « 9 »
•Lap time
•B ST lap
•Times of partial
•Nr of laps
•Nr of partial
•Difference on the lap
•Difference on partial
Race « 10 »
•Lap time
•B ST lap
•Times of partial
•Nr of laps
•Nr of partial
•Difference on the lap
•Difference on partial
Race « 11 »
•Nr of laps
Race « 12 »
•Lap time
•Times of partial
•Nr of laps
•Nr of partial
•Difference on partial
Note : You can c ange t e display w ile driving on t e circuit, wit t e
same button. Ot er windows will be available in t e future.
Copyright 2005 Alfano, S.A. Tous droits réservés. 9
Start a timing session
and use t e Alfano in race
Start a timing session
Upon detection of the start line,
the system displays window
race, timing and recording starts.
To c ange t e window in race
Then press the button at the top
right.
To enable or disable
t e backlig t in t e race
Press the button on the top
left.
Copyright 2005 Alfano, S.A. Tous droits réservés. 10
To close t e session
Press the button on the botton
left or botton right. STOP
appears for a few seconds.
Best laps
Before returning to the main
page, the ALFANO shows the
best time and the best time of
the last session
Table of contents
Other Alfano Timer manuals
