D. Method of operation
1. Put articles into the refrigerator 2to 3 hours after
start of operations, when the inside chamber is cooled down.
2. The height of the shelves can be freely adjusted conducive to store articles with
various sizes. Do not put heavy articles on the shelves to avoid cracking of the
shelves.
3. The refrigerator features a mounted microprocessor controlled thermostat. The
controller of the thermostat is located at the back of the refrigerator. To lower the
inside temperature, please turn the knob clockwise; if you desire higher
temperature, please turn the knob anti-clockwise.
4. There is a light inside the refrigerator，the light will automatically activate when
the door of the refrigerator is open.
Disconnect the power supply before replacing the light!
Steps for replacing the light are following:
(a) Unplug the power plug; (b) Remove the transparent light cover on the top of
the inside chamber; (c) Turn the burnt light anti-clockwise and take it out;
(d) Fit a new light and turn it tightly clockwise; (e) Put the light cover back.
E. Instructions for power conservation
1. Minimize the time of open doors, including when restocking with new articles.
Optimize your restocking process accordingly.
2. The refrigerator should be switched on for a minimum of 2 hours before putting
articles into the refrigerator, 3 to 4 hours is preferred.
3. Do not put warm articles into the refrigerator.
3. The setting of the inside temperature is around 8℃based on 25℃ambient
temperature. It can not be adjusted.
F. The thermoelectric refrigerator used for hotel rooms, is mainly designed for
drinks and wine. It is not designed as a freezer or for making ice.
G. Troubleshooting guide
To avoid contamination of food, please respect the following instructions
1. Opening the door for long periods can cause a significant increase of the
temperature in the compartments of the appliance.
2. Clean regularly surfaces that can come in contact with food and accessible
drainage systems.
3. Clean water tanks if they have not been used for 48h, flush the water system
connected to a water supply if water has not been drawn for 5 days.
4. If the refrigerating appliance is left empty for long periods, switch off, defrost,
clean, dry, and leave the door open to prevent mould developing within the
appliance.
H. Cleaning instruction:
Before any cleaning or maintenance operation, always unplug the appliance or
disconnect it from the power supply.
For manual defrost refrigerator compartment, defrosting of the refrigerator
compartment is completely automatic.
For manual defrost freezer compartment, defrost the low temperature
compartment when the ice formation is excessive. It is perfectly normal for ice to
form. The amount of ice which forms and the rate at which it accumulates will
Doesn’t Work
If power is on?
If connect with electrical outlet?
If lamp is on?
If ambient temperature is too high?
Inside temperature is not
enough
If door gasket is ok?
If ventilation accords to our requirement?
If ambient temperature is too high?
