Alarm Lock Trilogy PDL3500 User manual

Other manuals for Trilogy PDL3500

1

This manual suits for next models

13

Table of contents

Other Alarm Lock Lock manuals

Alarm Lock

Alarm Lock Trilogy DL3500 User manual

Alarm Lock

Alarm Lock Trilogy DL1200 Installation manual

Alarm Lock

Alarm Lock Trilogy PDK3000 Series Installation manual

Alarm Lock

Alarm Lock Trilogy PDL1300 Installation manual

Alarm Lock

Alarm Lock Trilogy PDL Series User manual

Alarm Lock

Alarm Lock TRILOGY DL2700 User manual

Alarm Lock

Alarm Lock Trilogy DL4100 Series Addendum Installation and operating instructions

Alarm Lock

Alarm Lock Trilogy PDL1300 User manual

Alarm Lock

Alarm Lock NARROW STILE ACCESS LOCKS Guide

Alarm Lock

Alarm Lock Trilogy ETDL Installation manual

Alarm Lock

Alarm Lock 80XGE User manual

Alarm Lock

Alarm Lock DL2500-SERIES Installation manual

Alarm Lock

Alarm Lock CYLINDER ADAPTER KIT Addendum Guide

Alarm Lock

Alarm Lock Trilogy DL3000 Series User manual

Alarm Lock

Alarm Lock DL2500-SERIES User manual

Alarm Lock

Alarm Lock PDL5300 User manual

Alarm Lock

Alarm Lock DL1200ET User manual

Alarm Lock

Alarm Lock TRILOGY DL2700 User manual

Alarm Lock

Alarm Lock EAGLE 4700DL Operating instructions

Alarm Lock

Alarm Lock T3 DL3500DB (DeadBolt User manual

Alarm Lock

Alarm Lock Trilogy DL4100 Series Addendum Installation manual

Alarm Lock

Alarm Lock DL 2700WP User manual

Alarm Lock

Alarm Lock Trilogy DL2700LD Installation manual

Alarm Lock

Alarm Lock 700 SERIES Manual

Popular Lock manuals by other brands

Magic

Magic 105 manual

Gantner

Gantner GAT NET.Lock 7020 System Installation, configuration & operation

Wittkopp

Wittkopp Insys 7202 manual

Dorma

Dorma Studio Classic Installation instruction

Securam

Securam ECSL-601 quick start guide

Sudhaus

Sudhaus 3003 operating manual

Safety 1st

Safety 1st 48517 user guide

Pado

Pado FDS-10 user manual

Esco

Esco systeQ Series installation instructions

COMPX

COMPX National D8951 instruction sheet

secureo

secureo Key Box instruction manual

Stock Loks

Stock Loks C8713 instruction sheet

COMPX

COMPX 1T-058 Information

Auslock

Auslock T11 user manual

ELCOM

ELCOM 7205 Operating instruction

Stealth SAFES

Stealth SAFES ShadowVault Instructions & Troubleshooting

Knox

Knox KeySecure 5 Admin & user guide

Kwikset

Kwikset 48334/01 Quick installation guide

ALARM LOCK

345 Bayview Avenue, Amityville, New York, U.S.A. 11701

For Sales and Repairs 1-800-ALA-LOCK • For Technical Service 1-800-645-9440

Fax: 631-789-3383 • [email protected]

Note: Technical Service is for security professionals only

ALARM LOCK Tech Support

TECH TIP

Date: Thursday, July 10, 2014

Subject: Securing an unlocked Trilogy lockset with a drained battery pack

Models: DL/PDL3500, DL/PDL4500, DL/PDL6500, ETDL, ETDLN, ETPDL, ETPDLN,

ETPLN, ETPDLNRX, ETPLNRX, PDL6600

When a valid code is entered and the batteries are weak, all Alarm Lock Trilogy locksets sound

a special low battery indication. We strongly recommend that weak batteries be replaced as

soon as this indication is heard. However, if weak batteries become completely drained while

the lockset is unlocked (i.e. in "Passage Mode"), use an ordinary 9-volt battery to change its

state to "locked" (disable "Passage Mode") as follows:

The 9-volt battery is used as a temporary substitute power supply, allowing the input of the

"Disable Passage Mode" command to re-lock the mechanism (and secure your property) until

you the proper replacement batteries can be obtained. In addition to the 9-volt battery, obtain

two short wires, both stripped at both ends.

1. Remove the battery housing cover and unplug the battery pack.

2. Take the two wires (for example, 12AWG, more or less, as convenient), stripped at both

ends, and insert one end of each wire into the battery connector plug found inside the lock.

Therefore, one wire will be in contact with the red wire of the battery connector plug, the

other wire will be in contact with the black wire of the battery connector plug. See the

image below.

3. Touch the red wire to the POSITIVE terminal of the 9-volt battery, and touch the BLACK

wire to the NEGATIVE terminal of the same 9-volt battery.

4. The lock will beep and the motor will run. Push the outside lever down; if the device

changes to a locked state, disconnect the 9-volt battery and remove the wires. If the

device remains open, maintain the 9-volt battery connections while the following keypad

buttons are pressed:

5. Press the current 6-digit Master Code and press [AL] until multiple beeps are heard. Press

[AL] [4] [9] []. Press [0] for 5 seconds until multiple beeps are heard (denotes exiting

ALARM LOCK

345 Bayview Avenue, Amityville, New York, U.S.A. 11701

For Sales and Repairs 1-800-ALA-LOCK • For Technical Service 1-800-645-9440

Fax: 631-789-3383 • [email protected]

Note: Technical Service is for security professionals only

Program Mode). Remove the 9-volt battery and the two wires. The device will now remain

in a locked state. Note: The metal keys (supplied with the lock) must be used until fresh

batteries are installed.