10
Factory pre-set pressure values:
PCI 1200 - 7 bar model: P1: P2: P3: P4:
End-pressure 1.0 bar 2.0 bar 3.0 bar 4.0 bar
Over-pressure: 0.5 bar 0.5 bar 1.0 bar 1.0 bar
(Resulting Set-pressure: 1.5 bar 2.5 bar 4.0 bar 5.0 bar)
PCI 1200 - 12 bar model: P1: P2: P3: P4:
End-pressure 1.0 bar 2.0 bar 3.0 bar 4.0 bar
Over-pressure: 1.0 bar 1.0 bar 1.0 bar 1.0 bar
(Resulting Set-pressure: 2.0 bar 3.0 bar 4.0 bar 5.0 bar)
Setting Pressure values - End Pressure and Over-pressure (Set Pressure):
“End pressure” + “Over-pressure” = “Set pressure”
On the PCI 1200 display, the chosen End-pressure of the wheel is shown with large
figures together with the measurement unit. Value is stored at “Start”.
Below is a status bar indicating the development of the inflation sequence cycle.
At the bottom of the display, the chosen Over-pressure is displayed.
The four programs P1 - P4 can be individually set and saved.
The End-pressure are set directly using the + / - keys.
The “Over-pressure” value is set by pressing and holding the P1 –P4 button until it is
highlighted in the display. Now the value is set using the + / - keys.
Store the value by holding the P1 –P4 button or by starting an inflation sequence,
pressing the “Start” button.
The minimum possible over-pressure is 0.2 bar. The highest possible Set-pressure is 7.0
or 12.0 bar depending on the PCI 1200 model (7 or 12 bar).
For safety reasons, the PCI 1200 inflate to Set-pressure before End-pressure.
However, not in Auto Mode, where the wheel has been previously pressurized.
Note: If the sum of selected End-pressure and desired Over-pressure values exceed
maximum system pressure (7 or 12 bar), then the PCI will not start inflating.
For instance (7 bar version): If the End-pressure is set to 5.5 bar and the Over-pressure is
set to 2.0 bar, then the resulting Set-pressure sum is 7.5 bar.
