8
Capture Button Functionality
In the Live Image mode — Capture button initiates live image capture.
• When Auto Focus is enabled and Capture button is pressed:
–Auto focus is initiated.
–Image is captured when auto focus completes.
–Image is analyzed if Pass/Fail analysis enabled.
–FOCIS Lightning®2 transitions to Captured Image mode.
–Save and send results to the Bluetooth-paired device if auto-save and auto-send
enabled on ‘1st Capture Key’.
–If auto-save or auto-send enabled on ‘2nd Capture Key’, press the Capture
button again to save and/or send.
• When Auto Focus is disabled and Capture button is pressed:
–Image is captured (without adjusting focus)
–Image is analyzed if Pass/Fail analysis enabled. .
–FOCIS Lightning2 transitions to Captured Image mode.
–Save and send results to the Bluetooth-paired device if auto-save and auto-send
enabled on ‘1st Capture Key’.
–If auto-save or auto-send enabled on ‘2nd Capture Key’, press the Capture
button again to save and/or send.
In all other modes — Capture button is used to return to the Live Image mode.
To Inspect MPO connector
1. Turn on FOCIS Lightning®2 by pressing the Power button on its left side.
2. Plug FOCIS Lightning2 adapter tip into MPO bulkhead adapter. The bulkhead
adapter could either be part of an MPO ber panel or, if inspecting MPO cabling,
a standalone MPO coupler.
3. The full MPO end-face in ‘x1’ view mode will be displayed on the FOCIS
Lightning2 display in less than two seconds.
4. Press the Capture button to initiate ber inspection and analysis.
