Adventure Kings A5 User manual

Heads Up Display (HUD)

USER MANUAL

Model: A5

Adventure Kings Heads Up Display

CONTENTS

1. Introduction to the HUD. ..............................................................3

2. Additional Information. ................................................................3

3. Unit Display & Switch Functions.................................................4

4. Menu Options. ..............................................................................6

5. Specications...............................................................................8

6. Troubleshooting ...........................................................................9

7. Installation................................................................................... 10

8. Warranty. ..................................................................................... 11

Adventure Kings Heads Up Display

INTRODUCTION TO THE HUD

The Adventure Kings HUD (Heads Up Display) contains multiple features that will make your driving

experience easier & in turn safer. The main feature of the HUD is projecting your current speed onto your

windshield. Along with this, the HUD will also indicate your current heading (N.E.S.W.) and has a togglable

option for a speed alarm that will give an audible beep when the chosen speed (default 150 km/h) has been

exceeded.

ADDITIONAL INFORMATION

• The speed displayed by the HUD is for reference only.

• Operation and adjustments to the HUD should not be performed whilst driving.

• Do not use chemical products to clean the HUD, they can cause damage to the unit. A damp cloth

should be sufﬁcient.

• When leaving a vehicle for an extended amount of time, un-plug the device to prevent battery

depletion.

UNIT DISPLAY & SWITCH FUNCTIONS

1. Speed Alarm

2. Setting Icon

3. Driving Directions Icon - West/East/North/South/West

4. Satellite Signal Icon – A red ﬂash indicates the device

is looking for a signal, green indicates the device is

connected to a satellite

5. Speed

6. Light-Sensor

7. Speed unit – Kilometres per hour (KM/H) or Miles per

hour (MPH)

To use the HUD, hold the unit with the switch on the left side, and the display facing up – as shown above.

Display Mode Menu

Short press – Forward - Increase value

Long press – Forward Reset to Factory Settings Rapidly increase value

Short press – In - Select / Next Setting

Long press – In Into Menu Back to Display Mode

Short press – Back - Decrease value

Long press - Back Speed Alarm Toggle Rapidly decrease value

Adventure Kings Heads Up Display

MENU OPTIONS

1. SPEED CALIBRATION

2. OVER-SPEED ALARM

3. BRIGHTNESS ADJUSTMENT

4. UNIT OF SPEED

5. AUTOMATIC POWER CUT-OFF

6. DISPLAY MODE

Default: 107

Range: 80 – 120

Description: It is common for car manufacturers to set the displayed speed of a vehicle

below that of the vehicle’s actual speed. In this case the HUD will show

a different speed to that of the vehicle’s odometer. You can calibrate this

through the HUD to prevent discrepancies. If for example your odometer is

showing 5 km/h slower than your HUD, you can adjust the value down from

107 to 102. This will align the two speeds presented to the driver.

Default: 150 km/h OR 150 mph

Range: 10 – 180 km/h OR 10 – 180 mph

Description: An audible beep will sound when the speciﬁed speed is exceeded. You can

disable this feature, through the main screen.

Default: 0 – Automatic adjust

Range: 0, 1 – 5

Description: 1 is the faintest and 5 is the brightest.

Default: 0 – km/h

Range: 0 – 1

Description: 0 – Km/h and 1 – MPH

Default: 100

Range: 100 – 150

Description: 100 (10Volts) – 150 (15Volts) when the unit detects the voltage drop below

this amount, the device will turn off.

Default: 0

Range: 0 – 1

Description: 0 the device projects data & 1 allows you to read current speed directly off

the unit.

Adventure Kings Heads Up Display

SPECIFICATIONS

HUD Size: 90mm x 52 mm x 13mm

HUD Weight: 40g

Speed Range: 0 – 400 km/h (250Mph)

Satellite Positioning Time: Start-up: 30s / Stand-by: 1s

Compass Precision: ±1°

Working Voltage: 8V – 18V DC

Working Current: 40mA

Stand-by Current: 15mA

12V Car Charger 1A

TROUBLESHOOTING

RESET TO DEFAULT SETTINGS

To revert to default settings, place the HUD with the display facing up and the switch on the left. From

there press and hold the switch forward until all the lights on the unit light up, this indicates that the HUD

has been reset. Then repeat the command to revert to the normal display mode.

HUD IS NOT LIGHTING UP WHEN PLUGGED IN AND THE CAR IS STARTED

Make sure that the device is correctly plugged in and that the cigarette plug is providing power to the

unit. If it is clear there is a solid connection and the unit is still not receiving power, try another outlet in

the vehicle or in another car.

INACCURATE SPEED DISPLAYED

Ensure you are using the correct unit of speed (kilometres or miles).

Press and hold the ‘Push’ function on the switch and navigate to option

1: (single cog) the default value will be 107, adjust this until your speed aligns with

what is displayed on your odometer.

Note: If you have changed the tyre size on your vehicle your odometer could be showing an incorrect

speed.

PROJECTED IMAGE IS HARD TO SEE

If the image is unclear and hard to see try using the reﬂective ﬁlm provided. If the reﬂective ﬁlm is already

applied; try manually increasing the brightness of the projected image in the menu.

Menu option 3: (cog, W, E) the higher the number, the brighter the display. The default

value is 0 which will automatically adjust brightness based on light levels.

Adventure Kings Heads Up Display

CAN’T FIND GPS SIGNAL

The ﬁrst time the HUD is powered, it will take ~30s for the device to achieve a GPS signal. If the device is

still failing to achieve a GPS signal, try moving to a new area with a clear view of the sky. Along with this,

you can reset the device to factory settings.

INSTALLING THE HUD

Connect the HUD to the cigarette plug using the provided cable.

When the vehicle is turned on the HUD will also turn on. The HUD will then start searching for a GPS

signal, indicated by a ﬂashing satellite symbol .

Position the HUD so that the projected image is easy for the driver to see, then use the included non-slip

mat to hold the HUD in place.

REFLECTIVE FILM

The option to use the protective ﬁlm is up to the user.

Use of the ﬁlm will ensure the user has the sharpest projected image possible.

Additionally, it will make the projected image easier to read in varying light conditions and avoid multiple

reﬂections (ghost images).

INSTALLING THE REFLECTIVE FILM

Installing the reﬂective ﬁlm is easy.

First, you will need to clean the area where you will place the ﬁlm, this can be done using a dry cloth.

Afterwards, take off the adhesive cover and place the ﬁlm so that the projected image is centred and

clearly visible.

Finally, can use a ﬂat item such as a bank card to remove any air bubbles present under the ﬁlm.

INSTALLATION

Adventure Kings Heads Up Display

WARRANTY PERIOD:

Full 12 month warranty from date of purchase against all manufacturing defects.

WHAT DOES THE WARRANTY COVER?

Under normal usage conditions, this warranty covers:

a. Any defect in design or manufacture which results in the product failing to perform substantially as

described in authorised advertising or literature.

b. We will either repair or replace the product at our discretion providing that the fault is found to have

been caused by a design or manufacturing defect and not misuse or tampering.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are

entitled to a replacement or refund for a major failure and for compensation for any other reasonably

foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods

fail to be of acceptable quality and the failure does not amount to a major failure. The beneﬁts provided

to you as the consumer by this warranty are in addition to other rights and remedies available to you

under the law.

THE WARRANTY DOES NOT COVER:

a. Any damage resulting from improper use

b. Faulty installation or modiﬁcation made during installation

c. The cost of removing and reinstalling the product

d. Travel and /or other expenses due to customer’s remote location

e. Transport charges and damage in transit. It is your responsibility to deliver and pick up your product,

including any costs associated with the postage of your repair or replacement product. If you do

freight your product we recommend that you insure against loss or damage.

f. Any loss directly or indirectly associated with the product failing to operate.

TO MAKE A CLAIM UNDER THIS WARRANTY PLEASE CALL

1800 88 39 64

12 MONTH LIMITED

WARRANTY

OUTDOOR SUPACENTRE PTY LTD

2 Stanley St Silverwater NSW, 2128

PHONE: 1800 88 39 64

www.4wdsupacentre.com.au

Adventure Kings Heads Up Display

Table of contents

Other Adventure Kings Monitor manuals

Adventure Kings

Adventure Kings AKEP-BM_01 User manual

Popular Monitor manuals by other brands

Linear Acoustic

Linear Acoustic LQ-1000 user guide

AOC

AOC I2579V user manual

Gateway

Gateway FPD1520 user guide

Furuno

Furuno Mu 120c Operator's manual

Asus

Asus VB171D - 17" LCD Monitor Service manual

Dell

Dell S2230MX Setting up

Philips

Philips 107C64 user manual

Dell

Dell S2409WFP user guide

EverFocus

EverFocus EN-7517E instruction manual

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Service manual

Dell

Dell Precision 7680 Connection guide

LG 50PM1M - - 50" Plasma Panel Service manual

Bosch

Bosch DDU 9 manual

Acer

Acer A231HL user manual

Philips

Philips 86BDL4152T user manual

NEC

NEC AccuSync LCD5V user manual

Emay

Emay SleepO2 user manual

IBM

IBM 6360 Product support manual