Advantech ICR-1601 Guide

Start Guide

ICR-1601

04-09-19

LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de

www.lucom.de

Start Guide

Safety Instructions

Please take care to following instructions:

•Use the router in compliance with national and international law and in compliance with

any special or additional restrictions regulating use of the router in the various applica-

tions and environments.

•To avoid possible injury and/or damage to the device, observe the relevant provisions

and standards. Use only the original accessories as recommended. Unauthorized de-

vice or accessory modiﬁcation, or using accessories that have not been approved can

result in router damage and/or violation of the regulations.

•Unauthorized device or accessory modiﬁcation or using the accessories that have not

been approved can result in warranty termination.

•Do not open the router.

•Caution! The SIM card can be swallowed by small children.

•When connecting the device to a power supply do not exceed the deﬁned voltage.

•Do not expose the router to extreme ambient conditions. Protect the router against dust,

moisture, and high temperature.

•It is recommended that you do not use the router at petrol ﬁlling stations. We recommend

observing local restrictions concerning the use of radio-based devices while working with

explosive material for example, at petrol ﬁlling stations, or in chemical plants.

•While using the router close to personal medical devices, such as cardiac pacemakers

or hearing aids, proceed with heightened caution.

•Operating the router too close to TV sets, radio receivers, personal computers, or tele-

phones can cause interference.

•It is recommended that you create a copy or backup of the important settings stored in

the memory of the router.

QSG-0005-EN, October 9, 2018 1Released in the Czech Republic

04-09-19

LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de

www.lucom.de

Start Guide

Product Disposal Instructions

The WEEE (Waste Electrical and Electronic Equipment: 2012/19/EU) direc-

tive has been introduced to ensure that electrical/electronic products are recy-

cled using the best available recovery techniques to minimize the impact on

the environment. This product contains high quality materials and components

which can be recycled. At the end of its life this product MUST NOT be mixed

with other commercial waste for disposal. Check with the terms and conditions

of your supplier for disposal information.

QSG-0005-EN, October 9, 2018 2Released in the Czech Republic

04-09-19

LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de

www.lucom.de

Start Guide

First Use

Before applying power to the router, connect the components that you required for your

applications. You cannot operate the router without connected antenna, inserted SIM card,

nor connected power supply.

If you do not have connected main antenna during operation of the router, the router can

be damaged!

1. Antenna

Use a SMA connector to connect the antennas to the router. The main antenna is con-

nected to the router by screwing on the ANT connector (see Figure below). The second diver-

sity antenna can also be connected to the DIV connector to improve performance.

2. SIM Card

The SIM card reader, for 3 V and 1.8 V SIM cards, is located on the front panel of the

router. If you intend to use this device to communicate over a cellular network, please place

an activated data-provisioned SIM card with an unblocked PIN into the SIM card reader. Push

your SIM card into the SIM1 or SIM2 slot until it clicks in place.

QSG-0005-EN, October 9, 2018 3Released in the Czech Republic

04-09-19

LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de

www.lucom.de

Start Guide

Before handling of the SIM card disconnect the router from power supply!

3. Power

The router requires an external DC power supply. The DC voltage required is between

+5 to +18 V DC. Please connect the power adapter DC 5 V/2 A to the PWR connector on the

panel of the router (see ﬁgure below).

QSG-0005-EN, October 9, 2018 4Released in the Czech Republic

04-09-19

LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de

www.lucom.de

Start Guide

4. Ethernet

An Ethernet cable may be connected to the LAN1 connector on the front panel (see Figure

above). By default, the Ethernet port is conﬁgured as follows:

Connector Purpose Default Setting

LAN1 LAN port (default)

Connect your laptop or PC to this port to

get a local web-server for device conﬁgu-

ration and diagnostics.

DHCP Server

IP Address: 192.168.1.1

NetMask: 255.255.255.0

Conﬁguration

1. Conﬁguring the Device Using the Web Browser

You can access the router for status monitoring, conﬁguration, and administration after en-

tering the IP address of the router into the web interface. The default IP address is 192.168.1.1

(netmask 255.255.255.0). Conﬁguration access is allowed for the user "admin" with the initial

password "admin". Attention, it is necessary to use HTTPS protocol for secure communication

over a network! For a detailed description and examples of the router conﬁgurations, see the

Conﬁguration Manual.

2. Restoring and Backing up the Router Conﬁguration

After you reset the router, the current conﬁguration is overwritten by the default settings.

We recommend that you back up the router conﬁguration before resetting the device. Refer to

the Conﬁguration Manual for more information.

When the Status LED starts blinking, it is possible to restore the default conﬁguration of the

router by pressing the Reset button on the panel continuously for 6 seconds. After pressing

this button, the default conﬁguration is restored and then the router reboots.

After logging on to the device for the ﬁrst time, we strongly recommend to change

the default password due to security reasons.

QSG-0005-EN, October 9, 2018 5Released in the Czech Republic

04-09-19

LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de

www.lucom.de

Start Guide

Documentation

User’s Manual, Conﬁguration Manual and manual for each expansion port can be found

and downloaded on this web site: www.advantech-bb.cz/download

Hereby, Advantech Co., Ltd. company declares that the radio equipment type

ICR-1601 is in compliance with EU Directive 2014/53/EU.

The full text of the EU Declaration of Conformity is available at the following internet

address: www.advantech-bb.cz/eudoc

QSG-0005-EN, October 9, 2018 6Released in the Czech Republic

04-09-19

LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de

www.lucom.de

04-09-19

LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de

www.lucom.de

Other manuals for ICR-1601

Table of contents

Other Advantech Network Router manuals

Advantech

Advantech SmartStart SL302 User manual

Advantech

Advantech ICR-2701 User manual

Advantech

Advantech EKI-2525 User manual

Advantech

Advantech MIC-3666 User manual

Advantech

Advantech B+B SmartWorx AirborneM2M BB-ABDN-ER-DP553 User manual

Advantech

Advantech SmartFlex SR307 User manual

Advantech

Advantech UR5i v2 Libratum User manual

Advantech

Advantech SmartFlex SR310 User manual

Advantech

Advantech B+B SmartWorx ER75i v2 User manual

Advantech

Advantech SmartStart SL302 User manual

Advantech

Advantech ICR-2437 User manual

Advantech

Advantech ICR-4434 User manual

Advantech

Advantech Libratum ICR-2834 User manual

Advantech

Advantech SmartMotion ST352 User manual

Advantech

Advantech EKI-7659C User manual

Advantech

Advantech B+B SmartWorx LR77 v2 Instruction sheet

Advantech

Advantech EKI-7626C User manual

Advantech

Advantech SmartFlex SR304 User manual

Advantech

Advantech ICR-3211 User manual

Advantech

Advantech CR10 v2 User manual

Advantech

Advantech EKI2726FHPI Series Installation and operation manual

Advantech

Advantech EKI-4524I User manual

Advantech

Advantech XR5i v2 Guide

Advantech

Advantech ICR-4401 User manual

Popular Network Router manuals by other brands

Allnet

Allnet ALL0333AU user guide

HomeSeer

HomeSeer HT-SEL Getting started guide

Sercomm

Sercomm Genesis OC3505D Quick installation guide

Billion

Billion BIPAC 5102 Series user manual

TP-Link

TP-Link TD-8817 QIG

Motorola

Motorola MR1900 user guide

Digi

Digi IX14 user guide

Cisco

Cisco NCS 540 Hardware installation guide

XAVi

XAVi X8821e user manual

BEC

BEC 6200WZL Quick installation guide

MikroTik

MikroTik hAP ac3 Series quick start

Korenix

Korenix JetNet 5428G Series user manual

NETGEAR

NETGEAR FS526T - Switch installation guide

Korenix

Korenix JetNet 5710G Series user manual

Automated Logic

Automated Logic ZN551 Technical instructions

Cisco

Cisco ASR 1000 Series Installation and configuration guide

EnGenius

EnGenius ESR-9710 quick start guide

Cisco

Cisco 805 Series Product overview