ADT Home Assure User manual
Where speakerphone
can be heard throughout
premises
Convenient for
resident to access
Good cellular
reception
Setting Up the EPP
The EPP in Action
1 2
3
Move the EPP at least
50 cm (20 in.) away
from the Control
Panel.
Press the button.
Press the PAIRING button
for 5 seconds.
The panel beeps and the
EMERGENCY button blinks
blue.
5"
Blue
50 cm (20 in.)
Panic Button
The EPP blinks red when the panic
button is pressed or a fall is detected
ADT MASTER LICENCES
NSW No. 406336543 VIC No. 652-156-12S, 652-156-91S WA No. SA61998 SA No. ISL 149773 ACT No. 17501831 QLD No. 40506
The EPP lights green when
the battery is replaced
Monitoring Station
Home Assure
The Best Location for the Control Panel
PERS
Control Panel and EPP Kit
Getting Started
For more information, see:
www.adtsecurity.com.au/home-assure
Phone 131 005
Place thumb
in oval hold
and lift off the
cover
Turn the power
switch on
Check backup
battery is
inserted or
insert
Connect the power cable
and plug into a power
source. Then close the back
cover
5
1
3
4
Setting Up the Control Panel
Check SIM
is inserted or
insert
2
Press to start an
emergency call.
Red light:
Press to cancel an
emergency call
Shows communication
status
●Green: if on, ready for
call. If blinking, message
being sent
●Red: if on,
communication failure
●Orange: active
conversation
Shows problem
status
●On: malfunction in
the Control Panel or
a peripheral
●Blinking: supervision
lost, or low battery in
a peripheral
Shows power status
●On: AC power
connected
●Blinking: using
battery
●Off: no power
Using the Control Panel
PAIRING button
●Blinking: alarm in
progress
●On: message
acknowledged
Other ADT Control Panel manuals
ADT
ADT Galaxy 16 Plus User manual
ADT
ADT PM33 User manual
ADT
ADT Unimode 9600 User guide
ADT
ADT DSC 1832 User manual
ADT
ADT 2 Gig Go! Control User manual
ADT
ADT Galaxy 8 Plus User manual
ADT
ADT 6128B User manual
ADT
ADT Unimode 400 Multi-Net User manual
ADT
ADT SafeWatch 3000 Use and care manual
ADT
ADT Command Hybrid User manual
