Adp HandPunch User manual
ADP HandPunch® LE
Quick Installation Guide
WARNING: Installation of your HandPunch will require you to address electrical,
telecommunication and other configurations and arrangements. You are advised to
consult appropriate professional technicians for the installation of your HandPunch.
Any deviation from the installation process contained in this Guide or from the
recommended use of the HandPunch may result in damage to the HandPunch, your
facility or personal injury. A damaged HandPunch may incorrectly transmit, alter or
lose your data. In no event will ADP be responsible for any such damage, injury,
alteration or loss.
Congratulations!
You are about to save time and increase
payroll accuracy by automating your
time and attendance.
This guide will show you the basic steps for
installing your ADP HandPunch.
Contents
Tools and Materials...............................................................................1
System Requirements .......................................................................... 2
Check the Contents of the Box......................................................... 3
Decide Where to Put the HandPunch .............................................. 6
Tape Mounting Guide to the Wall ..................................................... 7
Sheetrock Wall Installation............................................................... 8
Power and Communications Setup ..................................................... 9
Power and Communications Jack Installation (Direct
Connect)............................................................................................ 10
Power and Communications Jack Installation (Modem
Connect).............................................................................................11
Power and Communications Jack Installation (Ethernet
Connect)............................................................................................ 12
Fasten the Mounting Plate to the Wall ......................................... 13
Mount the HandPunch........................................................................ 14
Power and Communications Connection .......................................... 15
Attach the Power and Communications Cables (Direct
Connect)............................................................................................ 16
Attach the Power and Communications Cables (Modem
Connect)............................................................................................ 17
Attach the Power and Communications Cables (Ethernet
Connect)............................................................................................ 18
Complete the Mounting...................................................................... 19
Set Up the HandPunch Reader ........................................................20
Install the ADP HandPunch Manager Software..........................23
Reinstalling the ADP HandPunch Manager Software ............28
Appendix A: USB to Serial Adapter .............................................32
1
Tools and Materials:
Phillips screwdriver
Tape measure
Pencil & Ruler
Tape
Drill with ¼" bit
Scissors
2
System Requirements for:
Your PC Minimum Requirements
Operating System
• Windows 98; Second Edition
• Windows 2000, SP1
• Windows XP
• Windows NT v4.0, SP6
Internet Connection
• An existing internet connection. (Dial-up
56k+, DSL, Cable, T1/T3, ISDN, Frame
Relay)
• For HTTP Web Connectivity ensure that
firewall port 80 is open
Web Browser • Internet Explorer v5.5 or later
• Note: Macintosh/Netscape not supported
3
1. Check the Contents of the Box
One HandPunch reader
One backplate
One template
One set of keys
4
Three molly fasteners
Two auger connectors and screws
One CD
Connection equipment as follows:
5
Direct Connect:
Modem Connect:
Ethernet Connect:
No cable is included for Ethernet connect.
One 100’ or 250’
green cable
One modem cable
AND
One surge protector
6
2. Decide Where to Put the HandPunch
Make sure there are
no obstructions
within 12 inches of
any side of the
HandPunch.
Helpful Hint: We highly recommend
testing communications between the
HandPunch and computer before
running the cable and installing the
HandPunch to verify that the
computer’s communication ports are
operating correctly.
Pick a spot where all your employees can easily reach the
HandPunch and see its display. (Avoid locations where sunlight
may shine on the scanning plate.)
Other manuals for HandPunch
1
Table of contents
