Directions for use:
1.Turn on the Light
Turn on the strobe light by press the main power switch(4) to “I” position.the ready light(7) will shine red when the strobe in
fully charged for flashing.
2.Test Flash
Press the test button (12) to make sure the flash working.
3.Slave Sensor
Press the Sensor button (10),You can use the built-in slave sensor to trigger the light.
4.Synch Cord
Your light to your camera with synch cord to trigger the light. You may also consider triggering your flash by radio trigger,
infrared or even a camera flash.
5.Audio Signal
Pressing the key (6) to “I” position will activate an audio signal to remind you when the power has been fully recharged.
Pressing it to”0” position,when firing your flash the modeling lamp will be off automatically.
6.Modeling Lamp
There are many forms of modeling lamp. When set the switch (5) to "0", the modeling lamp is off. When set to "=", the
modeling lamp is on at full power. When set to "-" position, the modeling lamp varies in brightness corresponding with the
warious setting of the flash power by turning the OUTPUT CONTROL key (13).
7.Adjust Output Power for Flash
Choose different power settings with key (13) for different exposures. Full power to 1/16 power can be set. the strobe light
fires automatically when adjusting from high power down to low power.
8.Reflector Loading and Unloading
The reflector has 3 pins around the perimeter of it’s base. Line these pins up with the corresponding notches in the strobe
heads front collar. Then rotating the reflector clockwise until it locks into postion.to remove the reflector,push the locking bolt
on the top of the strobe and rotate the reflector counterclockwise,then pull it way from the strobe.
9.Replacing flash tube
Switch off the power for at least 10 minutes before changing the flash tube.
Wear gloves when replace the flash tube, first screw out the modeling lamp, then insert the flash tube. Please take care
and be safe,do not touch the anode and cathode of the flash-tube.
10.Audio Signal warning
When the light goes wrongly, the beeper will buzz for a long time to give you an alert.now please cut off the power
immediately and turn it on again. If the same situation repeats, send the strobe back to the store from which you buy it for
technical service.
Packing List:
Optional Accessories:
All reflectors that fit, Protective cover, Flashtubes and modeling lamps, Beauty dishes, Grids for reflectors, Barn doors,
Snoots, Spare sync cord and power cord, Ifra red trigger, Flashpoint accessories, New soft boxes, Speed rings list,
Flashpoint dedicated soft box with ring, Egg crate, Stands, Boom stand, umbrellas
MONOLIGHT 1220A/1820A/2420A
-2-
