ADEMCO 5802WXT User manual

ADEMCO 5802WXT Supervised Miniature

Transmitter – Installation Instructions

General Information

The ADEMCO 5802WXT is a wireless transmitter that may be worn around

the neck, on a wrist band or as an apparel clip that may also may be mounted

to a desk, dresser, etc. (necklace, band, and clip supplied). Pressing and

holding the transmitter button for two seconds sends a signal to the control

receiver. The 5802WXT is intended for use only with wireless alarm systems

that support 5800 Series devices.

The transmitter is supervised, i.e., it automatically sends a message to the

control receiver that includes battery status information every 70-90 minutes.

This transmitter can be programmed as any zone type response (e.g.,

Emergency Panics, Relay Action, etc.).

Programming the Serial Number

The 5802WXT has a unique identification code (serial number) permanently

assigned during manufacture.

You must “enroll” the transmitter’s serial number and loop number during

system programming. The 5802WXT may be defined as Input Type “RF”

(supervised RF, for an hourly check-in; do not take out of range) or “UR”

(Unsupervised RF). Its loop number is “1.” See the control unit’s Installation

Instructions for further details regarding programming. When installation is

complete, verify operation from desired location(s).

Battery Replacement

The 5802WXT is powered by a long-life Lithium battery that may be replaced

when a low battery is eventually indicated by the control unit.

NOTE: When replacing the battery, wait a minimum of 30 seconds prior to installing the

new battery.

NOTE: Although water-resistant, please do not immerse in water at a depth below

10cm for more than 1 hour.

1. Remove 4 screws and lift off

cover.

2. Using a small flat-blade

screwdriver remove old battery.

3. Insert new battery by placing

new battery under the gold tab

and then pressing down.

Ensure the POS + side of

battery is face up after

installation.

4. Align cover and attach with 4

screws.

Specifications

Unit Dimensions: 1.5” (3.9mm) Diameter

LED:

Lights when unit transmits.

Battery:

3-Volt 2032 Lithium

In ETL installations: 3V Panasonic or SENER

CR2032 only

REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL

WITH WHICH THIS DEVICE IS USED FOR WARRANTY INFORMATION AND FOR

DETAILS REGARDING THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM.

ETL US Listings: HOUSEHOLD BURGLARY WARNING SYSTEM CONTROL UNIT ACCESSORY ETL Canadian

Listings: HOUSEHOLD BURGLARY WARNING SYSTEM CONTROL UNIT ACCESSORY ALSO LISTED FOR USE AS

A SIGNAL APPLIANCE, MISCELLANEOUS CERTIFIED FOR CANADA.

FEDERAL COMMUNICATIONS COMMISSION STATEMENTS

The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions

or User's Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment.

FCC/IC STATEMENT

This device complies with Part 15 of the FCC Rules, and RSS 210 of IC. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received,

including interference that may cause undesired operation.

Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS 210 des Industries Canada. Son fonctionnement

est soumis aux conditions suivantes: (1) Cet appareil ne doit pas causer d' interferences nuisibles. (2) Cet appareil doit

accepter toute interference reçue y compris les interferences causant une reception indésirable.

IC MODEL: 5802WXT

SUPPORT & WARRANTY

For the latest documentation and online

support information, please go to:

https://mywebtech.honeywell.com/

For the latest warranty information, please go to:

www.honeywell.com/security/hsc/resources/wa

MyWebTech

Warranty

2 Corporate Center Drive, Suite 100

P.O. Box 9040, Melville, NY 11747

www.honeywell.com/security

Ê800-

090083Š

800-09008 5/11 Rev.

Table of contents

Popular Transmitter manuals by other brands

NIVELCO

NIVELCO EasyTREK SCA-300 Series Programming manual

Honeywell

Honeywell 5816WMBR installation instructions

Kamstrup

Kamstrup READy MTU Installation and operation guide

Omega

Omega ZW Series user guide

ABB

ABB Field 264H Instructions for installation

Alinco

Alinco DJ-V17T Service manual

Dejero

Dejero EnGo 3x manual

Rosemount

Rosemount 4600 Reference manual

Speaka Professional

Speaka Professional 2342740 operating instructions

trubomat

trubomat GAB 1000 instruction manual

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 instructions

Rondish

Rondish UT-11 quick start guide

MG 10JRE instruction manual

Burkert

Burkert 8177 operating instructions

Firetide

Firetide HotPort 3203 Hardware installation guide

Tele Radio

Tele Radio T9-02 User instructions

Rotronic

Rotronic HygroFlex HF3 Series user guide

Jamara

Jamara FCX6 Pro Tel Instruction