ActSafe ACX User manual

ACTSAFE ACX POWER ASCENDER

PRE-USE CHECKLIST

PLEASE NOTE: This document is a guide and must

only be used as an addition to the user manual.

1Battery connection

1.1 Check the ACX Battery Pack for damage to Battery Housing.

1.2 Check the Connector pins are clean and not damaged.

1.3 Check the Battery is charged and the Battery Strap present.

If you nd any inconsistencies

DO NOT use the ascender.

Contact your local Actsafe

Ascender distributor for advice.

A power ascender should never

be used without a backup system

when being used to lift people.

REMEMBER

Soak ropes

before rst use

IMPORTANT

iFor safety alerts and industry information

visit www.actsafe.se/safetyalerts

5Rope Wedge

Check Rope Wedge for deformation

or any visible damage. The Rope Wedge

should be straight, sit just above the bottom

of the Rope Grab and should not touch

the ribs on the inside of the Rope Grab.

6Rope Grab

Check the Rope Grab is clean and

not lled with dirt, sand, paint or any

other foreign material. Check the

inside for obvious damage, signs

of wear or sharp edges.

3Rope Guide

Check Rope Guide for obvious

damage, deformation or sharp

edges. Rope Guide should not be

bent and must t neatly with the

Rope Cover. Check wear indicator,

this should be completely intact.

4Rope Cover

Check the Rope Cover function by

unlocking and locking into its position.

The lock should snap into position.

Check the Rope Cover further for

deformation, excessive wear, or any

sharp edges.

7 Connection Sling and Carabiner

Check Connection Sling for wear,

discoloration or damage such as cuts,

abrasion and contaminants (paint,

glues, chemicals). Take particular note

of the condition of the Titanium Sling

olt and Karabiner Loop.

Inspect the carabiner for wear, damage

and deformation. Check that the

carabiner opens and locks correctly.

ACX II Pre Use Inspection Card Rev 1.0

2Ascender housing

2.1 Check Ascender Housing for cracks/severe damage.

2.2 Ensure Battery connector pins are clean and show

no sign of damage.

2.3 Check Rubber Sealing Rings are present (see right).

2.4 Slide the Battery onto the Ascender and check

it is locked in to position.

Rope Guide

Rope Wedge

Rope Grab

Rope Cover

Rubber Sealing Ring

2.4

2.1 2.3

2.2

Ascender activation

Check that the Emergency Stop is pulled out and switch Ascender

on. Wait for full activation of the Ascender (LED turns green).

ACTSAFE ACX POWER ASCENDER

PRE-USE CHECKLIST

PLEASE NOTE: This document is a guide and must

only be used as an addition to the user manual and

the battery safety and handling guidelines.

ActSafe Systems AB

Sagbäcksvägen 13

437 31 Lindome

Sweden

T: +46 31 65 56 60

E: [email protected]

www.actsafe.se

Contact ActSafe or your local ActSafe Ascender

distributor for more information.

Throttle Travel down

Travel up

Throttle, Rope Grab and Emergency Stop

Move the Throttle in both directions and ensure

the Rope Grab turns smoothly in both directions.

DANGER

If you nd any inconsistencies DO NOT use the ascender.

Contact your local ActSafe Ascender distributor for advice.

CAUTION

Do not use the ascender without a backup system when lifting

persons, see manual for further information on the correct use.

Emergency stop

Push the Emergency Stop

and check that the Ascender

is switched off and cannot

be activated by Power Button.

Emergency descent

Check that the emergency descent is working correctly.

The lever should return to neutral position when released.

ACX II Pre Use Inspection Card Rev 1.0

BLUE

Operation via Remote Control.

GREEN

Ascender is on/ready to use.

BLINKING GREEN

Ascender self-testing.

ORANGE

Ascender is overheated and

has shut down. Ascender can

be restarted after cooling down.

RED

Do not use the Ascender.

Refer to user manual.

Other manuals for ACX

Other ActSafe Lifting System manuals

ActSafe

ActSafe PMX User manual

Popular Lifting System manuals by other brands

morse

morse 82H-124 Operator's manual

Braun

Braun NL955 Series Operator's manual

haacon

haacon 1889.10 quick start guide

Protekt

Protekt AT 252 instruction manual

R. Beck Maschinenbau

R. Beck Maschinenbau HS 600 operating manual

Nova Technology International, LLC

Nova Technology International, LLC NAS Series quick start guide

Genie

Genie Z-60/34 Operator's manual

Screen Technics

Screen Technics INTERFIT Vertical Up Lift instructions

Mortuary Lift

Mortuary Lift ULTIMATE 1000 instructions

Custom Equipment

Custom Equipment Hy-Brid 3 Series MAINTENANCE & TROUBLESHOOTING MANUAL

Custom Equipment

Custom Equipment Hy-Brid Lifts 2 Series Maintenance and troubleshooting manual

Hy-Brid Lifts

Hy-Brid Lifts HB-P3.6 MAINTENANCE & TROUBLESHOOTING MANUAL

BERG

BERG BeNomic EasyLeaf Technical manual

Powermate

Powermate LiftGate LG-3 Installation & operation manual

Snorkel

Snorkel TM12 Series Operator's manual

Terberg

Terberg OMNIDEKA Translation of the original instructions

Harmar Mobility

Harmar Mobility AL625 Installation & owner's manual

Rotary

Rotary SPO16 installation instructions