70mai A800 User manual
70mai Dash Cam
User Manual
Contents
English ……………………………………………………………………………………………1
Русский ……………………………………………………………………………………………10
Español ……………………………………………………………………………………………18
Português …………………………………………………………………………………………26
日本語………………………………………………………………………………………………34
한국어………………………………………………………………………………………………42
繁體中文……………………………………………………………………………………………50
1
Indicator
Microphone
Power Button
Power Port
Rear Camera Port
Memory Card Slot
Product Overview
Note: Illustrations of the product, accessories, and user interface in the user manual are for reference purposes only. The
actual product and functions may vary due to product enhancements.
Please read this manual carefully before using the product and keep it in a safe place.
12 3 4 5 6 6
7
6
8
9
'&,1 $9,1 0LFUR6'
10
11
12
1
2
3
4
5
6
8
7
9
10
11
12
Function Buttons
Display
Speaker
Mounting Slot
Camera
Ventilation Holes
2
Installation
1. Installing the electrostatic sticker.
Clean your windshield and put the electrostatic
sticker on the recommended area as shown in the
figure below. Avoid the edge of the windshield and
select the flat and smooth area for the installation.
Make sure you remove air bubbles between the
sticker and the glass.
2. Installing the memory card.
Insert the memory card into the card slot with its
contacts facing up until you hear a click. The memory
card is well-installed.
3. Installing the mount.
Attach the mount into the slot and slide up, as shown
in the figure below. You will hear a snap when it is in
place. Make sure the mount is securely installed to
the dash cam.
4. Mounting the dash cam.
Peel off the protective film from the adhesive sticker
on the base of the mount, and paste the dash cam
onto the electrostatic sticker in the dotted area.
'&,1$9,1 0LFUR6'
3
Note:
●Use the included crowbar to hide the power cord underneath the vehicle's headliner and rubber seal along the A-pillar.
●Depending on the vehicle, the cigarette lighter socket may be located in a different position. The above figure is for
reference only.
5. Connecting the power supply.
As shown in the figure below, run the power cord along the top of the windshield, down the A-pillar, and around
the glove compartment, so that the power connector is near the cigarette lighter. Connect the power cord to the
car charger, then plug the charger into the cigarette lighter socket.
6. Adjusting the dash cam angle.
Turn on the dash cam and adjust the camera angle based on the preview screen to ensure that the camera is
facing the front of the vehicle .
4
1. 70mai Dash Cam A800×1
2. Mount ×1
3. Power Cord×1
4. Dual USB Car Charger×1
5. Wiring Crowbar×1
6. Electrostatic Sticker × 2
7. Adhesive Sticker × 2 (with 1 pre-applied to the
mount)
8. User Manual×1
Packing listAccessories (optional)
The rear recording function of this product needs
to be used with the rear cameras. Scan the QR code
below to obtain the operation guide for rear camera.
Note: To avoide the rear camera malfunction due to device
incompatibility, it is recommended to use a rear camera
from 70mai brand.
5
Download 70mai App
This product may be used in conjunction with the
70mai App. Please search for "70mai" in the App
Store or scan the following QR code to download and
install the App.
Note: Android 4.4 & iOS 9.0 or above is required to connect
to the dash cam's Wi-Fi hotspot with a mobile phone.
Online Guide
Scan the below QR code to access the online guide.
The guide provides detailed product information
including descriptions of functions. Please carefully
read this guide before use in order to avoid damage
due to incorrect use.
6
Memory Card Instructions
A memory card (sold separately) must be installed in the dash cam before use.
The dash cam supports standard MicroSD cards. Please use memory cards with the minimum capacity of 32 GB
and rating of U1(UHS-1) or above.
The default file partition format of the memory card may be inconsistent with the format supported by the dash
cam. When inserting the memory card for the first time, please format it in the dash came before use. Formatting
the memory card will delete all files on the card. Please back up important data to another device beforehand.
The memory card may become damaged or deteriorated after repeated cycles of overwriting, and this may affect
its ability to save video and image files. If this occurs, immediately replace it with a new memory card.
Please use a high-quality memory card purchased from a reputable vendor. Inferior memory cards may have
issues such as actual reading/writing speeds that do not match the stated speeds, and an actual storage capacity
that does not match the stated storage capacity. We shall not be held liable for lost or damaged videos caused by
the use of a low-quality memory card.
In order to avoid reading and writing speeds decreasing after prolonged use, it is recommended to format the
memory card in the dash cam every two weeks.
Do not insert or remove a memory card while the dash cam is turned on.
7
Precautions
Before using this dash cam, please read all the precautions and the online guide to ensure correct and safe use.
●This dash cam is intended to assist drivers with the purpose of recording the environment outside the vehicle.
The dash cam does not guarantee the user's driving safety. We shall not be held liable for any accident, damage,
or loss of information caused by operating the dash cam while driving.
●Due to differences in vehicle conditions, driving style, driving environment, etc., some functions may not work
properly. A power failure, usage in environments outside the normal operating temperature or humidity range,
a collision, or a damaged memory card may cause the dash cam to function abnormally. There is no guarantee
that this dash cam will function normally under all circumstances. Videos recorded by this dash cam are for
reference only.
●Please install this dash cam correctly, and do not block the driver's line of sight, nor block the vehicle's airbag, in
order to avoid product failure or personal injury.
●The maximum resolution of the single camera of the dash cam is 3840×2160; after installation of the rear
camera, the maximum resolution is 2560×1600. After removal of the rear camera, if you want to revert to
resolution 3840×2160, please change in Settings > Video settings > Video resolution.
●Please use the included car charger, power cord, and other accessories in order to avoid product failure due to
non-conformance. We shall not be held liable for any loss or damage caused by the use of a non-genuine car
charger or power cord .
●If the battery becomes deformed, swollen, or starts leaking during use or storage, stop using the dash cam
immediately in order to avoid safety issues, and contact after-sales service.
●Please keep this dash cam away from any strong magnetic fields, as they may cause damage to the dash cam.
●Do not use this dash cam in environments with temperatures over 60°C or below -10°C.
●Please only use this dash cam within the scope permitted by law.
8
FCC
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of 20 cm between the radiator & your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter.
Specifications
Product: Dash Cam Model: A800 Input: 5V 2A
Power Supply: Car cigarette lighter socket Battery Type: Lithium polymer battery
Table of contents
Languages:
Other 70mai Dashcam manuals
70mai
70mai A810 Series User manual
70mai
70mai Cam 1S User manual
70mai
70mai Midrive UP04 User manual
70mai
70mai X200 User manual
70mai
70mai A800S User manual
70mai
70mai X200 User manual
70mai
70mai Midrive D06 User manual
70mai
70mai Midrive D05 User manual
70mai
70mai S500 User manual
70mai
70mai Cam 1S User manual
70mai
70mai M500 User manual
70mai
70mai Pro Plus A500 User manual
70mai
70mai A810 Series User manual
70mai
70mai M200 User manual
70mai
70mai Lite User manual
70mai
70mai M300 User manual
70mai
70mai Dash Cam Pro Plus+ User manual
70mai
70mai A400-1 User manual
70mai
70mai M500 User manual
70mai
70mai A800S-1 User manual
